Symmons Duro 361TS Series Manual

Duro®
Model Numbers Specification
361TS, 361DTS
Tub Spout Series
Operation & Maintenance Manual
☐361TS Non-Diverter Tub Spout
☐361DTS Diverter Tub Spout
☐361TS-SS Non-Diverter Slip Spout
☐361DTS-SS Diverter Slip Spout
Dimensions
Measurements
A 2-1/4", 57 mm
B 2-1/2", 64 mm
C
Male 1/2-14 NPT tting
must protrude
3-7/8" (98 mm)
from nished wall
D 5/8", 16 mm
E 5-5/8", 143 mm
F
1/2" rigid copper tubing
must protrude
Min. 1-3/4" (44 mm)
Max. 2-3/4" (70 mm)
from nished wall
Note: Dimensions subject to change without notice.
AA
BB
CCDD
EE
AA
BB
CCDD
EE
361TS361TS
361DTS361DTS
F
F
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Warranty
Note: Append appropriate -sufx to model number.
Options/Modifications
☐-BBZ Brushed Bronze finish
☐-MB Matte Black finish
☐-STN Satin Nickel finish
• 5-5/8" length
• Pull-up diverter (361DTS)
• Thread on installation
• Optional slip spout with 1/2" inlet
• Metal construction plated in standard polished chrome
nish
Compliance
-ASME A112.18.1/CSA B125.1
WARNING: This product can expose you to chemicals
including lead, which is known to the state of
California to cause cancer, birth defects, or other
reproductive harm. For more information, go to
www.P65Warnings.ca.gov.

Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■Phone: [phone] ■ Fax: [phone]
Copyright © 2018 Symmons Industries, Inc. ■symmons.com ■[email protected] ■ZV-3018 REV G ■ 101918
Installation (Thread On)
Installation (Slip Spout)
Troubleshooting Chart
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
Tools Required for Installation
Allen Wrench:
5/32"
Tools Required for Installation
Plumber Tape
3-7/8"
(98 mm)
1) Male 1/2-14 NPT tting must
protrude 3-7/8" (98 mm) from
nished wall
2) Apply plumber tape to threads on
tting.
1
2
3) Thread tub spout (361TS or 361DTS)
onto tting.
Min. 1-3/4" (44 mm)
Max. 2-3/4" (70 mm)
1) Rigid copper tubing must protrude
1-3/4" (44 mm) - 2-3/4" (70 mm)
from nished wall.
2) Attach tub spout (361TS or 361DTS)
to rigid copper tubing.
3) Install set screw to secure tub spout
to rigid copper tubing.
Caution: Ensure seal is not damaged by making sure outside
of 1/2" diameter rigid copper tubing is free of burrs and
sharp edges prior to installing tub spout.