Symmons Maxline 7-230-CK-FS User manual

4
Installation
Sizing Valve
For assistance in sizing and selection of the proper
valve, consult your local representative or Symmons
Customer Service.
Installing Valve
1) Flush piping thoroughly prior to installing.
2) Install valve so as to allow clearance for replacing
cartridge. Valve can be installed in any orientation.
protective cap
retaining nut
cartridge
4"
102 mm
Valve
clearance
(C) COLD
supply port
(H) HOT
supply port
(M) MIXED
output port
3) Connect valve input/ouput to supply ports.
a. Hot port marked (H)
b. Cold port marked (C)
c. Mixed output port marked (M)
Setting Valve Temperature
1) Turn hot and cold water supply on.
2) Open faucet to allow hot water to ow for a
minimum of one minute. For two handle faucets
turn on hot water only. For single handle faucets
turn on to the hot position.
3) Remove the safety cap by inserting a small at
tip screw driver into the wide slot at the base of
the cap and pry upward, then ip the safety cap
over 180 degrees and t onto the end of valve
spindle.
Temperature
Adjust
Protective Cap
4) Place thermometer in the outlet stream. Measure
and accurately set temperature. Inlet temperature
must be ± 10°F (5.55°C) of desired output.
5) To increase temperature turn safety cap
counter-clockwise. To decrease temperature turn
safety cap clockwise.
For single temperature applications adjust valve
outlet temperature with full ow of tempered
water from tting.
For dual temperature applications open
approximately 50% of all faucets to their full hot
position to ensure proper operating temperature
at peak demand.
6) Remove safety cap from end of valve spindle and
ip over 180 degrees, then press cap down and
snap back onto valve body to replace.
Note: Once the safety cap is snapped onto the
valve body the outlet temperature cannot be
changed without repeating steps 2-6.
Warning: Water temperatures in excess of
110°F (43°C) may cause scalding or
severe injury!

2
Dimensions
Note: Dimensions subject to change without notice.
7-225-CK-MS
7-225-CK-PEX
7-225-CK-F, 7-230-CK-FS 7-230-CK-M
Measurements
A 6 7/16”, 164 mm
B 6 9/16”, 167 mm
C 3 1/8”, 79 mm
D 6 3/4”, 171 mm
E 6 11/16”, 170 mm
F 3 1/4”, 83 mm
G 7”, 178 mm
H 6 13/16”, 173 mm
I 3 3/8”, 86 mm
J 7”, 178 mm
K 6 13/16”, 173 mm
L 3 3/8”, 86 mm
A
B
C
D
E
F
G
H
I
K
L
J

5
HOT
WATER
TANK,
HEATER,
ETC.
Main hot supply
Cold supply
Lavatory
faucet Tub
valve
(V1) valve
(V2)
MAXLINE
valve
MAXLINE
valve
Tempered
hot supply
Tempered
hot supply
Cold supply
Single supply faucets Two supply faucet
Tempered hot supply
High temperature hot supply
(if required for laundry, etc.)
valve
Thermometer
recommended
HOT
WATER
TANK,
HEATER,
ETC.
MAXLINE
valve
Point of Use Diagram
Multiple Fixtures Diagram
Installation