Synca JP-1000 User manual

5009444
JP-1000
Massage Chair
Product Name :

Inlet (power cord plug-in port)

Power cord

※Lace the yellow hose
as instructed in the
left description.

※
If the torsion is
severe, it is
removed once
and fixed again
so that the
torsion severity
is less
①Match the groove of hose from arm
unit and projection of hose from main
body, then insert it along the groove.
②Lock the both
parts while pushing.
Projection
Groove
Arm unit side Main body side
※Turn the
both parts
firmly till
the end.
①
②③
①
②③
①
②③
①
②③
※Tighten the
screws lightly at
first and
retighten the
screws firmly by
the hex wrench
of accessory.
Screw the Arm unit.
The remote control stand is also screwed together during remote control stand
fixation. When screwing them as follow.
①DQWHURLQIHULRUĺ②DQWHURVXSHULRUĺ③posterosuperioe
ƔRemote control stand is usually fixed in left hand side.
ƔPress the arm unit firmly toward to the frame and screw it.

4.
After the installation of armrest,
check if there is any dislocation
in the back of armrest.
Check if there is
any dislocation.

Insert the connector of the power cord into the inlet
(power cord insertion port) at the lower right of the
rear side of the main body.
Insert it firmly.
Do not use any electrical cables
other than the supplied cord.
Check that the power cord,
remote control cord, or power
plug is not damaged or that
there is no dust on the power plug.
Connector
Inlet
Mount the power cord
Insert the power plug and connector to the root without fail and do not allow dust to adhere.