TOOLS REQUIRED: 1. SCREWDRIVER(PHILLIPS HEAD NO. 2)
2. HAMMER
ASSEMBLE INETRUCTION SHEET
A. PARIS LIST
NO
#1
#2
#3
#4
#5
#6
#7
#8
#9
#10
#11
#12
#13
FIGURE
DESCRIPTION (MM)
WORK-TOPS
SLIDE BASES
BOLTS (HEX)
CROSSBARS
LEG FRAMES
PLASTIC TEET
WASHERS
WOOD SCREWS
BOLTS (PHILLIPS)
NUTS
NUTS
CHOCKS
WASHERS
QTY
2PCS
2PCS
4PCS
2PCS
2PCS
4PCS
4PCS
16PCS
8PCS
8PCS
4PCS
4PCS
8PCS
16. 0 8 1. 2
4.8mm 16mm
M6 P1.0 37mm
M6 P1.0
M8 P1.2
1361.2
B. ASSEMBLY STEPS:
STEP 1:USE BOLTS(# 9) WASHERS(#13) AND NUTS (#10)TO
CONNECT CROSSBARS (#4) AND LEG FRAMES (#5)
STEP 2: USE WOODSCREWS(# 8) TO CONNECT SLIDE BASES (#2)
AND WORK-TOPS (#1)
STEP 3: FIT LEG FRAMES (#5) INTO SLIDE BASES (#2),LINE UP
HOLES IN SLIDE BASE WITH HOLES IN LEG FRAME INSERT
BOLTS (#3)AND WASHERS(#7)FROM OUTSIDE OF THE
BASE AND ATTACH WASHERS (#7) AND NUTS(#11) FROM
INSIDE USE SCREWDRIVER AND SPANNER TO
TIGHTEN SCREWS.
STEP 4:ATTACH PLASTIC FEET (#6) TO THE LEGS (#5). EACH FOOT
MUST BE ATTACHED WITH LONGEST SIDE T OUER
CORNER WHICH IS INDICATED BY ARROW INSIDE.
STEP 5: SELECT SUITABLE HOLES ON THE WORK-TOPS TO FIX
CHOCKS(# 12)
REMARK:
1. DO NOT USE AS LADDER.
2. LOAD CAPACT MAC 100 KGS
UNSAFE TO STAND ON.
