Target CAPRI 2000 User manual

COMPONENTS / HARDWARE
2
ALLOW 30 MINUTES
FOR ASSEMBLY 2 PEOPLE REQUIRED
FOR ASSEMBLY
IMPORTANT:
On initial assembly, DO NOT tighten bolts
completely until all parts are joined. Once
all parts are joined,
flip table over, ensure all legs are even.
Once even, tighten bolts.
PRE-ASSEMBLY PREPARATION
BEFORE YOU START
1.Choose a clean, level, spacious assembly area.
2.Avoid hard surfaces that may damage the product.
3.Check and ensure you have all required contents for complete assembly.
4.Always read the assembly instructions carefully before beginning.
5.The packaging and contents can be a choking hazard, therefore keep out of
reach of small children at all time.
6.Do not over tighten bolts as this may damage the thread.
A
G
FED
C
B
1PC 2PCS 1PC
20PCS M6*20 20PCS 20PCS
1PC
H
2PCS
CAPRI BENCH 2000

2
FINISH
STEP 3: STEP 4:
STEP 1: STEP 2:
.
TO THE TOP,DO NOT OVERTIGHTEN.
PUT TABLE TOP (A) ON THE FLOOR,ATTACH TABLE LEG (B) AND (H) TAKE FIXED FRAME (C) TO MATCH THE HOLE OF THE LEG,USE SCREW (D)
AND (E) TO CONNECT,TIGHTEN ALL SCREW AND PUT ON CAP (F).
NOW YOUR TABLE IS READY FOR USE.
FLIP TABLE OVER,ENSURE ALL LEGS ARE EVEN.
ONCE EVEN,COMPLETELY ALL BOLTS.
BE CAREFUL NOT TO OVERTIGHTEN AS THIS MAY DAMAGE THREADS.
H