Technaxx TE15 User manual

Technaxx®* User Manual
Aroma Smartphone Car Holder TE15
Aroma Smartphone holder for car’s ventilation grilles
The Declaration of Conformity is under the Internet link: www.technaxx.de/
(in bottom bar “Konformitätserklärung”); Before using the device, read the user
manual carefully.
Service phone No. for technical support: 01805 012643 (14 cent/minute from
German fixed-line and 42 cent/minute from mobile networks). Free Email:
[e-mail]
First Steps
Push the TE15 holder’s cover on the back in the direction of the arrow (see
picture). Take out a new Aroma Tab from the Aroma Tab package and insert it
in the free space for the Tabs; or take out the old Aroma Tab by pulling the
plastic part, and then insert a new one. Close the holder’s cover against the
arrow direction.
Place the screw cap over the
ball joint of the ventilation bracket
(see left in the figure). Do not twist
yet!
Snap the vent holder onto the
TE15 mount’s ball joint. You will
hear a “snap” sound when it is
properly connected.
Tighten the screw cap to the
cradle by turning it clockwise.
Weight / Dimensions: 71g (withAroma tab) / (L) 8.5 x (D) 10 x (H) min.11/max.17cm
Suitable for Smartphones of 3.5-6 inches

How to attach the TE15 mount to the air vent
Attach the Smartphone holder to the car’s ventilation. Ensure that the slots of
the silicone-coated ventilation bracket are aligned parallel to a slat of the
ventilation slots. Carefully slide the bracket onto one of the slats. Then insert
the Smartphone (as shown in the figure, description below) into the holder.
NOTE: The air vent in each car
can vary.
When aligned the bracket, be
careful not to break the air vent.
How to remove the TE15 mount from the air vent
First remove your Smartphone from the cradle. Removing the Smartphone
from the cradle is exactly the opposite process to the insertion (it is described
below). Gently pull back the holder from the slat of the car’s ventilation.
How to put the Smartphone into the cradle
Push the center release button (in the below middle); push it up to exend
the cradle to its most extended position. Place your Smartphone into the
cradle and push down the top of the cradle until it clicks in to a locked and
secured position. NOTE: Be sure to push your Smartphone all the way in until
the back touches the cradle before into position.

How to get the Smartphone out off the cradle
While holding the top of the bracket with one hand and push it slightly back,
pull out your Smartphone from the cradle. Move the upside of your
Smartphone out of the holder around 30° in the direction. Take out the
Smartphone in the direction. Move the Smartphone outward lightly, in order
not to damage itself or the cradle.
NOTE:
Attach or remove the holder from the
ventilation as well as insert or remove
either the Smartphone or Aroma Tab
ONLY when the vehicle is stationary
and its engine is switched off.
Caution regarding the Aroma Tabs: Keep out of the reach of
children. IF IN CONTACT WITH SKIN: wash with plenty of water
and soap. If medical advice is required, provide packaging or
labeling. May cause an allergic skin reaction. Causes serious eye
irritation. Toxic to aquatic life with long lasting effects .
Hints for Environment Protection: Packages materials are raw
materials and can be recycled. Do not disposal old devices or
batteries into the domestic waste. Cleaning: Protect the device
from contamination and pollution (use a clean drapery). Avoid
using rough, coarse-grained materials or solvents/aggressive
cleaner. Wipe the cleaned device accurately. Distributor:
Technaxx Deutschland GmbH & Co.KG, Kruppstr. 105, 60388
Frankfurt a.M., Germany
Keep this user manual for future reference or product sharing carefully. Do the same
with the original accessories for this product. In case of warranty, please contact the
dealer or the store where you bought this product.
Warranty 2 years for the Aroma Smartphone Car Holder TE15 only.