TeleEye MX833-HD User manual

1
Quick Start Guide
TeleEye MX833-HD Network Camera
This Quick Start Guide will guide you how to install and configure TeleEye MX833-HD network camera for remote video
monitoring.
Camera Installation
Step 1: After mounting the camera on the wall or ceiling, connect the power cable with a 12VDC supply and connect
the Ethernet cable to the LAN adapter as the follows:
Step 2: Run sureSIGHT or Web browser to start the remote video monitoring in order to adjust the camera.
[Reference] Please refer to the following sections for understand how to start video monitoring.
Step 3: After removing the camera’s cover, adjust the direction (pan/tilt/rotation) of the camera (the left diagram
below),the focal and the focus by sliding the sticks at the side of the lens (the right diagram below).
Step 4: Tighten the screws to fix the direction of the camera module. Finally, close the camera's cover.
DC12V IN
Alarm cable
Ethernet Cable
Adjust focus
Adjust focal
Rotation
Tilt
Pan

2
IP Setup Utility
Step 1: After installing sureSIGHT and turn on the IP camera, select the “Run TeleEye IP setup utility” from the
windows start menu.
Step 2: From the IP setup utility, match your own MX833-HD by its unique serial number. You can change its IP/port,
etc. on the right side of the window. Press [Apply] button when you finished.
[Note] The default password is “000000”.
Live Monitoring with Web-Browser
Step 1: On the PC side, open a web browser and type in the IP address of the MX833-HD. (Assume
“210.17.139.107” is the MX833-HD’s IP address in this case, type “http://210.17.139.107” in the web
browser).
Step 2: Select the connection type and input the password.
[Note] The default password is “000000”.

3
Step 3: Click the [Connect] button to connect the video stream. And the video stream will be displayed on the
browser as below:
Live Monitoring with sureSIGHT
Step 1: After installing sureSIGHT and turn on the IP camera, select the “Run sureSIGHT Lite”from the windows
start menu.
Step 2: Input the password in the password dialogue box, and then
click the button.
[Note] Default password for administrator is "000000".

4
Step 3: Click the [Quick connect] button on the main toolbar to connect to the IP camera.
Step 4: Select the target camera by its serial number or site name from the list table on the left.
Step 5: Click the button to confirm all the site information. And then the sureSIGHT will connect to the target
camera. [Note] The default camera password is 000000
[Reference] For more details of the operations, please refer to the sureSIGHT user manual.
END