Teltonika RUT900 User manual

Quick start guide v1.1
RUT900 HSPA+ Router
CERTIFIED
ORGANISATION
ISO 9001
4
This sign on the package means that it
is necessary to read the User's
Manual before you start using the
device.
This sign on the package means that all
used electronic and electric equipment
should not be mixed with general
household waste.
Please visit our web site for more informationwww.teltonika.lt
Login to device
1. To enter router's Web interface type in your internet browser.http://192.168.1.1
2. Use the following parameters when prompted for authentication:
User name: admin
Password: admin01
3. Configuration Wizard will start after logging in. It is necessary to complete Configuration Wizard to
setup router to correct mode. You can leave default settings but it is strongly recommended that you change
the password and enable Wireless Security.
4. Go to Status > Network Information and pay attention to Signal Strength. To maximize the
performance try adjusting antennas or changing location of your device to achieve best signal conditions.

23
Hardware installation
1. Remove back panel and insert SIM cards which were given by your ISP (Internet Service Provider).
Correct SIM cards’ orientation is shown in the picture.
Front panel Back panel
1, 2, 3 LAN Ethernet ports
4 WAN Ethernet port
5, 6, 7 LAN LEDs
8 WAN LED
9 Power socket
10 Power LED
11 GSM connection status LED
12 GSM signal strength indication LEDs
1 3G auxiliary antenna connector
2 3G main antenna connector
3,5 WiFi antenna connectors
4 Reset button
2. Attach 3G and WiFi antennas.
3. Connect the power adapter to the socket on the front panel of the device. Then plug the other end of the
power adapter in to a wall outlet or power strip.
4. Connect to the device wirelessly (SSID: Teltonika_Router) or use Ethernet cable and plug it in to any
LAN Ethernet port.
5. Choose the wireless network Teltonika_Router from the list and Connect.click
2. Setup wireless network adapter on your computer
( ight click on Wireless Network Connection and r
select Properties. After that select Internet Protocol
Version 4 (TCP/IP) and click Properties).
3. Select Obtain IP address automatically and
Obtain DNS server address automatically if they
are not selected. Click OK.
4. Right click on Wireless Network Connection and
select Connect/Disconnect to see available
wireless networks.
Configure your computer (using Windows 7)
1. Enable the wireless network connection ( o to Start > Control Panel > Network and Internet > Network g
and Sharing Center. In the left panel click Change adapter settings link. Right click on Wireless Network
Connection and select Enable).
SIM1 (primary) SIM2 (secondary)