Teltonika FMC225 Installation guide

FMC225
WATERPROOF LTE CAT 1 TERMINAL
WITH RS485/RS232 INTERFACES AND
BACKUP BATTERY
Quick Manual v1.6

Quick Manual v1.6 // FMC225 2
CONTENT
Know your device................................................................................................................................................................................................3
Pinout ...................................................................................................................................................................................................................4
Wiring scheme.....................................................................................................................................................................................................5
Set up your device ..............................................................................................................................................................................................6
PC Connection (Windows)..................................................................................................................................................................................7
How to install USB drivers (Windows) ..............................................................................................................................................................7
Conguration.......................................................................................................................................................................................................8
Quick SMS conguration................................................................................................................................................................................. 10
Mounting recommendations.......................................................................................................................................................................... 12
Mounting recommendations with U-type cable .......................................................................................................................................... 13
Basic characteristics ........................................................................................................................................................................................ 14
LED indications................................................................................................................................................................................................. 14
Electrical characteristics.................................................................................................................................................................................. 17
Safety information .......................................................................................................................................................................................... 19
Certication and Approvals ............................................................................................................................................................................ 20
Warranty ........................................................................................................................................................................................................... 21
Warranty disclaimer ........................................................................................................................................................................................ 21

Quick Manual v1.6 // FMC225 3
KNOW YOUR DEVICE
2x6
SOCKET
STATUS
LED
NAVIGATE
LED
DUAL SIM
SLOT
BATTERY
SOCKET
GNSS
ANTENNA
TOP VIEW TOP VIEW (WITHOUT COVER)BOTTOM VIEW (WITHOUT COVER)

Quick Manual v1.6 // FMC225 4
PIN NUMBER PIN NAME DESCRIPTION
1VCC (10-30) V
DC (+)
Power supply (+10-30
V DC).
2AIN 1 Analog input, channel 1.
Input range: 0-30 V DC.
3 RS232 – RX Input for data receive
through RS232
4 RS232 – TX Output for data transmit
through RS232
5DIN 1 Digital input, channel 1.
6INPUT 6 TX EXT (LVCAN – TX).
7GND (-) Ground pin. (10-30) V DC
8 DOUT 1
Digital output, channel
1. Open collector output.
Max. 0,5 A DC
9RS485 – A Signal A wire for RS485
10 RS485 – B Signal B wire for RS485
11 1WIRE DATA Data for 1–Wire devices.
12 INPUT 5 RX EXT (LVCAN - RX).
PINOUT
RS485-A
RS485-B
1WIRE DATA
GND
DOUT1
INPUT 5
RS232-RX
RS232-TX
DIN1
+10...30 V DC
AIN1/DIN2
INPUT 6
10
9
8
7
11
12
4
3
2
1
5
6
FMC225 2x6 socket pinout

Quick Manual v1.6 // FMC225 5
WIRING SCHEME
30
8586
87a
87
BUFFERED
TRANSPARENT
MODE
BUZZER
FUEL GAUGE
STARTER
IBUTTON
POWER SUPPLY
10 - 30V DC
ANALOG
LLS SENSOR
RS232
LLS SENSOR
MULTIPLE RS485
LLS SENSORS
CAN-CONTROL
ALARM BUTTON
GARMIN
RFID
IGNITION
DETECTION
RS485-A
RS485-B
1WIRE DATA
GND
DOUT1
INPUT 5
RS232-RX
RS232-TX
DIN1
+10...30 V DC
AIN1/DIN2
INPUT 6
10
9
8
7
11
12
4
3
2
1
5
6
IRIDIUM EDGE®

Quick Manual v1.6 // FMC225 6
SET UP YOUR DEVICE
HOW TO INSERT MICRO-SIM CARD AND CONNECT THE BATTERY
1
4
PARTLY CLOSED DEVICE
BATTERY CONNECTION
3
6
SIM CARD INSERT
COMPLETELY CLOSED
DEVICE
IMPORTANT!
2
5
COVER REMOVAL
ATTACHING COVER BACK
You will receive your device
partly closed.
Connect battery as shown to
device. Position the battery
in place where it does not
obstruct other components.
Gently remove top and
bottom covers.
After conguration, see “PC
Connection (Windows)1”,
attach device top and bottom
cover back and press them
twice to the full closure.
1 Page 7, "PC Connection
(Windows)
Insert SIM card as shown with PIN request disabled or read
our Wiki1how to enter it later in Teltonika Congurator2. Make
sure that Micro-SIM card cut-o corner is pointing outward
from slot. SIM slot 1 is closer to PCB, SIM slot 2 is the top one.
1 wiki.teltonika-gps.com/view/FMC225_Security_info
2 wiki.teltonika-gps.com/view/Teltonika_Congurator
Make sure that product
casing is closed correctly.
This device has an IP67 casing
with a two-phase closing, that
ensures reliable protection and
ease of use. Please make sure
that product casing corner clips
are xed tightly and cable is
connected to the device in order
to maintain the degree of IP67
protection.

Quick Manual v1.6 // FMC225 7
PC CONNECTION (WINDOWS)
HOW TO INSTALL USB DRIVERS (WINDOWS)
1. Please download COM port drivers from here1.
2. Extract and run TeltonikaCOMDriver.exe.
3. Click Next in driver installation window.
4. In the following window click Install button.
5. Setup will continue installing the driver and eventually the conrmation window will appear. Click Finish to complete the
setup.
1 teltonika.lt/downloads/en/FMC225/TeltonikaCOMDriver.zip
1. Power-up FMC225 with DC voltage (10 – 30 V) power supply using supplied power cable. LED’s should start blinking, see “LED
indications1”.
2. Connect device to computer using Micro-USB cable or Bluetooth connection:
• Using Micro-USB cable
• You will need to install USB drivers, see “How to install USB drivers (Windows)2”
• Using Bluetooth
• FMC225 Bluetooth is enabled by default. Turn on Bluetooth on your PC, then select Add Bluetooth or other device >
Bluetooth. Choose your device named – “FMC225_last_7_imei_digits”, without LE in the end. Enter default password 5555,
press Connect and then select Done.
3. You are now ready to use the device on your computer.
1 wiki.teltonika-gps.com/view/FMC225_LED_status
2 Page 6, "How to install USB drivers"

Quick Manual v1.6 // FMC225 8
MS .NET REQUIREMENTS
Operating system MS .NET Framework version Version Links
Windows Vista
Windows 7
Windows 8.1
Windows 10
MS .NET Framework 4.6.2 32 and 64 bit www.microsoft.com1
1 dotnet.microsoft.com/en-us/download/dotnet-framework/net462
At rst FMC225 device will have default factory settings set. These settings should be changed according to the users needs. Main
conguration can be performed via Teltonika Congurator1software. Get the latest Congurator version from here2. Congurator
operates on Microsoft Windows OS and uses prerequisite MS .NET Framework. Make sure you have the correct version installed.
1 wiki.teltonika-gps.com/view/Teltonika_Congurator
2 wiki.teltonika-gps.com/view/Teltonika_Congurator_versions
CONFIGURATION

Quick Manual v1.6 // FMC225 9
Downloaded Congurator will be in compressed archive.
Extract it and launch Congurator.exe. After launch software
language can be changed by clicking 🌐in the right bottom
corner.
Conguration process begins by pressing on connected device.
FMC225
Various Status window1 tabs display information about GNSS2,
GSM3, I/O4, Maintenance5and etc. FMC225 has one user
editable prole, which can be loaded and saved to the device.
After any modication of conguration the changes need to
be saved to device using Save to device button. Main buttons
oer following functionality:
 Load from device – loads conguration from device.
 Save to device – saves conguration to device.
 Load from le – loads conguration from le.
 Save to le – saves conguration to le.
 Update rmware – updates rmware on device.
 Read records – reads records from the device.
 Reboot device – restarts device.
 Reset conguration – sets device conguration to
default.
Most important congurator section is GPRS – where all
your server and GPRS settings6 can be congured and Data
Acquisition7– where data acquiring parameters can be
congured. More details about FMC225 conguration using
Congurator can be found in our Wiki8.
After connection to Congurator Status window will be
displayed.
FMC225
1 wiki.teltonika-gps.com/view/FMC225_Status_info
2 wiki.teltonika-gps.com/view/FMC225_Status_info#GNSS_Info
3 wiki.teltonika-gps.com/view/FMC225_Status_info#GSM_Info
4 wiki.teltonika-gps.com/view/FMC225_Status_info#I.2FO_Info
5 wiki.teltonika-gps.com/view/FMC225_Status_info#Maintenance
6 wiki.teltonika-gps.com/index.php?title=FMC225_GPRS_settings
7 wiki.teltonika-gps.com/index.php?title=FMC225_Data_acquisition_
settings
8 wiki.teltonika-gps.com/index.php?title=FMC225_Conguration

Quick Manual v1.6 // FMC225 10
QUICK SMS CONFIGURATION
Default conguration has optimal parameters present to ensure best performance of track quality and data usage.
Quickly set up your device by sending this SMS command to it:
Note: Before SMS text, two space symbols should be inserted.
GPRS SETTINGS:
 2001 – APN
 2002 – APN username (if there are no APN username,
empty eld should be left)
 2003 – APN password (if there are no APN password,
empty eld should be left)
SERVER SETTINGS:
 2004 – Domain
 2005 – Port
 2006 – Data sending protocol (0 – TCP, 1 – UDP)
« setparam 2001:APN;2002:APN_username;2003:APN_password;2004:Domain;2005:Port;2006:0»
1 2 3 4 5 6
1
2
3
4
5
6