6
OPERATION
MAINTENANCE
1. For cleaning, always unplug the heater and leave it to cool.
2. Wipe the heater regularly with a damp cloth and dry the surface before turning on the heater again.
3. The heater must be cleaned at least once a month during the heating season.
4. Dust etc. should be removed with a soft cloth.
5. The heater can be stored in a dry and clean place.
1. Turn on:
Plug in and switch on the heater. After “BI” voice, the heater enter into standby mode and show icon
on display. Press button to turn on the heater, and display show room temperature.
2. Temperature setting:
A. Temperature setting range is 5~50ºC.
B. Default temperature setting is 15ºC.
C. Press or button to set temperature, icon flash, the temperature will increase or
decrease by 1ºC after each pressing and save in 3 seconds if no action. The display will show room
temperature after setting.
D. If room temperature is 1ºC higher than setting temperature, it will stop heating; if room temperature is
2ºC lower than setting temperature, it will start heating.
3. Power setting:
Press button, low power output and show icon on display; press button again, medium
power output and show icon on display; press button again, high power output and show
on display.
4. Timer
A. Under turn on mode, press button to enter into 24 hours turn off timer setting, and icon
flash, then press or button to set timer, the timer will increase or decrease by 1 hour after each
pressing and save in 3 seconds if no action and show icon on display. Timer setting range is 0~24
hours.
B. Under standby mode, press button to enter into 24 hours turn on timer setting, and icon
flash, then press or button to set timer, the timer will increase or decrease by 1 hour after each
pressing and save in 3 seconds if no action and show and icons on display. Timer setting range is
0~24 hours. You also can set temperature and power for turn on timer. You also can cancel turn on timer
by pressing button and heater will turn on directly.
5. Anti frost function
A. If heater is under standby mode and room temperature is lower than 5ºC, the heater will start heating
and show icon on display.
B. When room temperature reach 10ºC, the heater will stop heating.
C. If temperature sensor fault, it will show “E2” on display.
CAUTION!
The heater should never be immersed in water.
Avoid using detergents to clean the heater.
Never let any water get inside the heater; this can be
hazardous.
