Texecom Premier Elite Impaq Contact-W User manual

Technical Support : 91520 10269 : [e-mail]
Press 1234 on the control panel. The below message will be displayed.
Press Yes
Press reset button
When it starts learning you need to insert the battery into the Impaq contact-W
Premier Elite Impaq Contact-W (GBB0003)
Press Yes till you reach zone type
Note: In this case
we’re learning
sensor in zone 105.
Press any free zone number (eg: 105) to learn your Impaq contact-W
Note: Before learning the
sensor we need to place
the jumper in relearn

Technical Support : 91520 10269 : [e-mail]
Press Menu ( ) two times on the control panel and then press Yes to logoff
from your control panel
Frequently Asked Questions:
1. What would be the maximum distance between the device and magnetic
contact?
Ans: The magnetic contact distance is
Press Yes 7times to reach zone mode(wiring) & make zone wiring as
“always awake”
2. How to convert third party wired sensors to wireless sensor?
Ans: Inside the device we have an option for converting the third party wired
sensors to wireless sensor by using MAG1 & COM or MAG2 & COM.
OR
Non-Ferrous
Mounting Material
Ferrous Mounting
Material
Maximum Break 30mm 15mm
Minimum Make 15mm 5mm
3. How to identify the status of sensor using LED?
Ans: Below are the details of the LED status.
Colour Status Description
Flashing Green With all contacts secure, will flash every 3
seconds.
Red Indicates either he reed switch or external
contact are active.