Thermaltake Pacific A2 Ultra User manual

© 2021 Thermaltake Technology Co., Ltd. All Rights Reserved. www.thermaltake.com
Pacific A2 Ultra Memory Water Block
CL-W333-CU00SW-A
Memory Module Installation Guide
Parts List
Type 1
Type 2
Please confirm the RAMs are single sided or double
sided,single sided please refer to Type 1,
double sided please refer to Type 2.
2
1
4
3
5
Remove the protective film of Thermal Pad on Heat Sink(B) and Heat Sink(C). Install the RAMs on Heat Sink(B).
Please be aware of the direction and the position.
Attach Thermal Pad(D)
to the Heat Sink(B)
Attach Thermal Pad(G)
to the Heat Sink(C)
Use the Screws(H) to enclose the
HeatSink(B) and HeatSink(C). Finished
Type 1
B
B
B
BC
C
G
D
C
H
A x 1 D x 8 E x 1 G x 4 H x 12 I x 8
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment.
Before you start using this product please follow these basic guidelines:
1. Please read carefully through the instruction manual before beginning the installation process.
2. Please remove your graphics card from your motherboard to ensure the safest process and in order to prevent any possible damages to your CPU and motherboard.
3. It is strongly recommended using market proven pre-mix coolant, such as Thermaltake Coolant 1000.
Water Block
B x 4
Heat Sink
C x 4
Heat Sink Thermal Pad Thermal Pad Thermal Pad
(Thick) Screw Screw
J x 1
Controller Cable
Thick

© 2021 Thermaltake Technology Co., Ltd. All Rights Reserved. www.thermaltake.com
Pacific A2 Ultra Memory Water Block
CL-W333-CU00SW-A
Installation Guide
Memory Module Installation Guide
1
3
2 3
4
Plug the complete memory module to
the DDR4 slot on the motherboard.
Please refer to the motherboard manual
for the installation location.
Remove the protective
film of Thermal Pad
from the Water Block(A).
Attach Thermal Pad(E)
to the Water Blcok .(A)
Tighten the Screws(I)
until memory module
are securely attached.
I
J
Connect the Controller
Cable to Water Block
Type 2
1
3
2
Remove the protecive film of Thermal Pad
from Heat Sink(B) and Heat Sink(C)
Attach Thermal Pad(D)
to the Heat Sink(B)
Attach Thermal Pad(D)
to the Heat Sink(C)
Install the RAMs on Heat Sink(B).
Please be aware of the direction and the position.
B C
B4 5
Finished
Use the Screws(H) to enclose the
HeatSink(B) and Heat Sink(C).
BC
H
B C
DD
E
5
Install your fittings and tubes