Thermaltake Pacific V-RTX 3070 Plus User manual

VGA Water Block
Pacific V-RTX 3070 Plus
Q
100
80
80
45 45
910
90
30
unit : mm
A B
C
C
D
E E F
A
B
C C
D
E
F
A x 1 B x 1
2
Remove the power connector
(Carefully detach the original stock cooler)
Remove the screws circled on the diagram. All heat sink assembly screws should be removed.
When installing the water block, carefully position the water block with the preinstalled standoffs on the graphics card.
Remove the screws circled on the diagram.
All heat sink assembly screws should be removed.
Cut the thermal pads to the dimensions listed and place them on the spots shown on the diagram.
Parts List
7
Apply thermal compound
Clean the original thermal compound off the GPU die
Finish
1
65
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment.
Before you start using this product please follow these basic guidelines:
1. Please carefully read through the instruction manual before beginning the installation process.
2. Please remove your graphics card from your motherboard to insure the safest process and in order to prevent any possible damages to your CPU and motherboard.
3. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000.
4
3
8
C x 10 D x 2 E x4 F x 6 H x 2 I x 1 Q x 8 G x 2
I
E
C
D
G
F
BC

VGA Water Block
Pacific V-RTX 3070 Plus
Parts List
Installation Guide
9
11
12
13 14
10
J
N
Connect the Waterblock onto the controller.
J
A
N
123
45
Set the DIP switch on the back side of the controller to assign the
number of the controller
J
NO.1
ON
1 2 3 4
NO.3
ON
1 2 3 4
NO.2
ON
1 2 3 4
NO.4
ON
1 2 3 4
NO.9
ON
1 2 3 4
NO.1 1
ON
1 2 3 4
NO.1 0
ON
1 2 3 4
NO.1 2
ON
1 2 3 4
NO.5
ON
1 2 3 4
NO.7
ON
1 2 3 4
NO.6
ON
1 2 3 4
NO.8
ON
1 2 3 4
NO.1 3
ON
1 2 3 4
NO.1 5
ON
1 2 3 4
NO.1 4
ON
1 2 3 4
NO.1 6
ON
1 2 3 4
K
K
Connect the controller cable onto the mainboard (USB 2.0 9 pin)
and controller.
If you want to connect two or more connectors, you can use the bridge
cable to connect the controllers.
M M
Connect the power cable to the 4pin Molex connecter and controller.
L L
Jx 1 Kx 1 Lx 1 Mx 1 Px 1Nx 1 Ox 1
Controller Power Cable Velcro Controller Cable Bridge Cable LED Y - Cable MB SYNC Cable
Connect the LED Y-Cable onto the waterblock.
ON
1 2 3 4
© 2021 Thermaltake Technology Co., Ltd. All Rights Reserved. www.thermaltake.com