THERMEx Oxford Decor 501LED User manual

Oxford - Decor 501LED
1
Dansk
Norsk
Svenska
English

33

DK
2W×4
190W
230V-250V/50Hz 150mm
62dB(A)
51dB(A)
48dB(A)
3
800m /h
3
600m /h
3
360m /h
Motor input
Technical specifications
Technical specifications
Model no.
Lights
Voltage
Noise level
Dimension (mm)
Pipe dia.
Air volume
Packing list
Model no. Name Qty
User instructions
Cooker hood
Flue cover panel
Extension cover panel
Bracket for cooker hood
Flex pipe
UK
600X600X1060
Oxford / Decor 501 FH-LED
Oxford / Decor 501 FH-LED
Oxford / Decor 501 FH-LED
3

2
(CKB motor kan benyttes
som alternativ til Combi loft motor)
CKB
COMBI LOFT
COMBI VÆG MOTOR
DK: Generel Info
*Thermex anbefaleraltid at benytte lyd- og kondensisoleret aftræksslange ved gennemføring i ikke-opvarmede rum.
Ved brug af flexslange anbefales det at benytte en lyddæmper for at minimere lydniveauet.
Vær opmærksom på, at emhættens oprindelige aftræksdimension sikrer optimal udnyttelse.
I de tilfælde hvor man vælger at reducere aftræksdimensionen, medfører det øget lufthastighed samt øget modtryk i aftrækskanalen.
Dette medfører mindre ydeevne og højere lydniveau.
Det anbefales derfor altid at benytte den oprindelige aftræksdimension.
Ved brug af flexslange, skal det altid sikres at denne er fuldt udstrakt for at minimere luftmodstanden og derved opnå maksimal sugeevne,
samt minimalt lydniveau.
Derudover er der mulighed for at benytte faste rør (spirorør eller plastrør) for yderligere at minimere luftmodstanden i kanalsystemet.

DK
Cleaning the cooker hood
External:
Clean the cooker hood with a damp cloth and a small
amount of detergent.
Do not use caustic, abrasive or inflammable liquids for
cleaning. By applying ”steel cleaner” from Thermex
to the stainless steel surfaces, the cooker hood will
not be as susceptible to dirt or finger marks.
Cleaning the grease filter:
Cleaning should take place as and when necessary, but at
least once every two months. The more the cooker hood is
used, the greater the cleaning frequency required.
Remove the filter by pushing the grey plastic handle
towards the wall and pulling the filter downwards.
Clean the filter in warm water with detergent or in the
dishwasher at max. 60 degrees Celsius.
NB. If cleaned in the dishwasher, the filter may become
slightly discoloured.
If the cooker hood does not work:
Check that the plug is inserted in the socket
Make sure that the plug socket is switched on
Check whether the fuse has blown
Check whether the grease filter is clean
If the cooker hood has been purchased as new in Denmark,
any manufacturing or material defects found during the
normal use of the cooker hood will be remedied here in
the country.
For Greenland and the Faroe Islands, special rules apply.
In the event of any claims, please contact the dealer
from whom you purchased the cooker hood.
UK
6.5cm
B
A
100cm
φ165mm
φ8mm
Find det rigtige sted til monteringen
(Fig. 1). Bor 6x8mm huller og skær et
165mm hul til aftrækket ved hjælp af
skabelon (Fig. 2)
Fjern monteringsflangen fra kanalen
og monter den i de 6 huller med evt.
rawplugs og tilhørende skruer. (Fig. 3)
4

DK
Operation
The best results can be achieved by running the cooker
hood at low speed during normal conditions and high
speed if the odour is more concentrated. Switch on the
cooker hood 2-3 minutes before commencing cooking, as
this will create a negative pressure in the kitchen.
The cooker hood should run for a further 15 minutes
after cooking or until any odours are exhausted.
Control panel:
Low speed
Medium speed
High speed
Light ON/OFF
If pressed once, the cooker hood switches off
after approximately 1 minutes
If pressed twice, the cooker hood switches off
immediately
NB! The control panel is touch-sensitive and thus you
cannot feel a function being depressed; simply placing
your finger on the appropriate switch will be
sufficient to activate it.
UK
Monter aftræksslange på emhætten (Fig. 4)
Fjern de 4 skruer i bunden af kanalen og placer denne på emhætten
(Fig. 5) og skru emhætten fast på kanalen me d de 4 skruer. (Fig. 6)
5

DK
Installation
UK
Step 5
Tighten the chimney to the mounting flange using five M5 x 10 screws
（Fig.7).
5
Fastgør kanalen på monteringsflangen ved hjælp af 5 stk. M5
x10 skruer.
6

DK
Installation
UK
Step 3
Insert the duct on the duct connection, fix the duct using two ST2.9*10
screws(Fig.4).
Step 4
Remove the four nuts from the chimney, place the chimney onto the
hood until is fully inserted(Fig.5), tighten the chimney to the hood using
four nuts(Fig.6).
7

Installation
Before installation
Check that the cooker hood is undamaged. Any transport damage
must be reported to the haulage carrier immediately. Damaged,
defective or missing components must be reported to the dealer
immediately.
Installation
UK
DK
Thermex
6.5cm
B
A
100cm
φ165mm
φ8mm
Step 1
Find the right place to mou nt(Fig.1).Drill six
8mm dia. holes and a 165mm dia. hole using
the paper(Fig.2)
Step 2
Take out the mounting flange from the chimney, fasten the mounting
flange to the ceiling using the six 8mm dia. screw anchors and
corresponding screws(Fig.3).
8

NO
2W×4
190W
230V-250V/50Hz 150mm
62dB(A)
51dB(A)
48dB(A)
3
800m /h
3
600m /h
3
360m /h
Tekniska detaljer
Tekniska detaljer
Modellnummer
Lampa
Spänning
Ljudnivå
Motor input
Mått (mm)
Slangdiameter
Luftmängd
Förpackningen innehåller
Modellnummer
Namn
Bruksanvisning
Spiskåpa
Skärm
Förlängningsskärm
Fäste till spiskåpan
Flexslang
Antal
SE
600X600X1060
Oxford / Decor 501 FH-LED
Oxford / Decor 501 FH-LED
Oxford / Decor 501 FH-LED
11