Thetford Aqua-Magic V Instruction Manual

Permanent RV Toilet
Fresh Water Flush
Operation
Aqua-Magic V
Hand or pedal flush
Record Your Product ID In-
formation Here
See Parts page for location of
Product ID/serial number labels.
NOTE: Removal of Product ID/
serial number label can void
your warranty.
Hand operation
Aqua-Magic STYLE II & STYLE
PLUS
China Bowl – Pedal Flush
Bravura
Pedal flush
Pedal operation
Bravura
Aqua-Magic STYLE Plus
To add water, press halfway
To flush, press all the way
Aqua-Magic
Residence
Pedal Flush
Aqua-Magic Residence
Aqua-Magic STYLE II
Aqua-Magic V
Model

Trouble Shooting
1. Leaks:
A. Back of toilet: check water
supply line connection at water
valve. Resecure or retighten as
necessary. If leak persists from
water valve, replace.
B. Vacuum breaker leaks while
flushing: replace Vacuum
Breaker or water module,
depending on model.
C. Between closet flange and
toilet: check flange nuts for
tightness. If leak continues,
remove toilet and check flange
height. Use Thetford spacers
to adjust, if necessary, to 7/16”
above floor. Replace flange
seal.
2. Toilet won’t hold water:
A. Check for and remove
any debris from blade/ball
seal track.
B. Check blade/ball seal
compression with mecha-
nism. If blade/ball seal is
worn, replace.
3. Harder than normal pedal
or hand lever operation:
Apply light film of Thetford
Toilet Seal Lubricant &
Conditioner or silicone
spray to blade/ball. (Note:
To avoid damage do not use
spray lubricants other than
silicone.)
4. Poor flush: Pedals or hand
levers must be held fully
open during flush. A good
flush should be obtained
within 2 to 3 seconds. If prob-
lem persists, remove the wa-
ter supply line and check flow
rate. The flow rate should be
at least ten quarts (9.5 liters)
per minute.
Winterizing
Antifreeze Method
Use RV(potable) antifreeze only.
Draining Method
Turn off RV’s water supply. Drain
toilet bowl. Disconnect supply
line at water valve. Completely
drain the toilet’s water supply line.
CAUTION: To avoid
damage, when using air pres-
sure to blow water from lines,
be sure toilet valve is open.
CAUTION: If water is
frozen in the toilet, do not at-
tempt to flush until ice thaws.
!
!
CAUTION: Never use
automotive type antifreeze.
!

3
3
2
2
11
Fig. 2
Bolt Pattern Bravura
Fig. 3Fig. 1
1:Aqua-Magic V,
Bravura,
Aqua-Magic Residence,
Aqua-Magic STYLE
1, 2, 3: Bravura
(if replacing
Starlite/Galaxy)
Front/
Installation
Required Tools
■Adjustable wrench
■1/2” ratchet or box wrench
If carpeted:
■Carpet cutting tool
■Marker or chalk
For adequate flush, a 3/8” I.
D. water supply line with good
flow is required
Procedure
1. Remove old toilet and closet flange
seal.
2. Attach new closet flange seal to new
toilet, lip side down (Fig. 1).
3. STYLE Plus and Bravura
only: Remove shroud from base of
unit (Figs. 3 & 4).
With mounting bolts in place, posi-
tion toilet over closet flange (Fig. 2).
If not carpeted, go to Step 5.
4. If carpeted, trace around toilet,
remove toilet and cut away carpet to
expose floor. Carpet beneath pedal
may also need to be removed.
5. Reset toilet. Using body weight, press
toilet to floor.
6. Tighten nuts until toilet is stable. Do
not overtighten.
7. Connect water line to water valve/
elbow using 1/2” NPT tube fittings.
8. Turn on water and flush. Check for
leaks.
9. Bravura only: Install Shroud
(Fig. 3). STYLE PLUS only:
Attach shroud to toilet by depressing
pedal and placing the pedal opening
over the pedal and pushing it firmly
against the base. Press the sides of
the shroud to the toilet and attach
two O-rings on the hooks to secure it.
Make sure to engage dual lock under
front of shroud by tapping shroud
above pedal
(Fig. 4).
STYLE PLUS
Fig. 4
Plumbing required:
Removal
Follow the installation directions in
reverse order.

b
a
11”/11po
c
d
Options
(Option with Bravura,
Aqua-Magic V, Aqua-
Magic STYLE & Aqua-
Magic Residence)
■Easy to attach to
existing water valve
Dimensions
Front View
e
Side View
Wal
STYLE
PLUS
STYLE
II
a: 19.84”/po 14.37”/po
b: 15.6”/po 15.6”/po
c: 19.76”/po 19.76”/po
d: 34.13”/po 28.62”/po
e: 9-1/2”/po 9-1/2”/po
Profile
High Low
a: 20.04”/po 15.24”/po
b: 16”/po 16”/po
c: 21.1”/po 21.1”/po
d: 34.3”/po 29.5”/po
e: 11”/po 11”/po
This toilet was designed to
be compatible with Thetford
brand holding tank deodorants.
Use Thetford Aqua-CleanTM non-
abrasive cleaner with a soft-bristle,
non-abrasive bowl brush, sponge or
soft cloth. DO NOT USE SCOUR-
ING POWDERS, ACIDS OR CON-
CENTRATED CLEANERS, WHICH
CAN DAMAGE SURFACES, PLAS-
TIC PARTS AND RUBBER SEALS.
FAILURE TO DO SO CAN VOID
YOUR WARRANTY.
Deodorizing
Cleaning
Hand spray
Thetford Toilet Riser
■Increases comfort
■Raises toilet 2.5
inches
■Fits all Aqua-Magics
and Bravura
Profile
High Low
a: 18-1/2”/po 14”/po
b: 15 -1/8”/po 15-1/8”/po
c: 17-1/8”/po 17-1/8”/po
d: 32-1/4”/po 28-1/8”/po
e: 11”/11 po 11”/11 poa:
a: 17-7/8”/po 14”/po
b:16-9/16”/po 16-9/16”/po
c: 20-3/16”/po 20-3/16”/po
d: 34-3/8”/po 30-1/2”/po
e: 11”/po 11”/po
a: 19.5”/po 14.0”/po
b: 15.3”/po 15.3”/po
c: 19.8”/po 19.8”/po
d: 34.1”/po 28.6”/po
e: 9.5”/ po 9.5”/ po
Bravura
Aqua-
Magic V
Aqua-
Magic
Residence
Wal

Aqua-Magic V
2
8
1
1
7
4
Before ordering parts, record the Product
ID information. Specify High or Low.
No. Description
1. Seat and Cover (sold as set only)
2. Vacuum Breaker*
3. Flush Tube
4. Flush NozzleAssy.
5. Hand Spray Kit (Water Saver Option Only)
6. MechanismAssembly
7. Closet Flange Seal & Bolt Package
8. Water Module/Water Valve
9. Water Valve Link
10. Water Valve DriveArm
11.Cable Replacement Pkg.†
12.Pedal Pkg.†
13.Return Spring (Style Plus)
14.Waste Ball
15.Blade Seal
16.Bowl
17.Shroud (specify high or low)
18.Bolt Caps
19.Shroud O-Rings
20.Waste Ball DriveArm
21.Pedal Cover Insert
† Pedal Flush only
Bravura
6
5
7
8
17
12
3
1
Parts
8
11
416
8
10
14
11
15 17
19
18
13
5
15
9
15
5
20
7
12†
18
*In the event of Vacuum Breaker failure
the Vacuum Breaker Assembly must be
replaced.
12
21
20
ID Label/
Aqua-Magic STYLE PLUS
Aqua-Magic STYLE II
Aqua-Magic Residence
ID Label
ID Label/
12