10
TTiimmeerrpprrooggrraammmmiinnggaanndd
rreeccoorrddiinngg
To record an analogue channel ensure that the aerial connections to your VCR are as shown in
the connection diagram and use the VCR as normal.
To record a digital channel, connect the receiver directly to your VCR via the VCR scart socket
on the rear of the receiver (see connection diagram). Please consult your VCR user manual for
details on recording via AV or AUX inputs. For RF recordings select tuned channel on the VCR.
The TIMER PROGRAMMING function enables the receiver to :-
●Automatically switch to your pre-selected channels at pre-selected times.
●Start Auto Record on the VCR (where the VCR supports scart automatic
recording function, see your VCR manual for details on this.)
NOTE: The system may not accept a start time less than 5 minutes ahead of the current clock
time displayed in the menu.
1. Press [MENU], select TIMER PROGRAMMING and
press [OK].
2. Using //select a free event, or select an event you
wish to alter and press [OK].
3. Using select the program you wish to record or
use 0..9 to enter the number directly, e.g. 003.
4. Press to select the date and enter the date directly
using 0..9 or use //to choose.
5. Press to select the time and enter the start time
directly using 0..9 or use //to choose.
6. Press to select the duration and enter the length of
the program using 0..9 or use //to choose.
7. Press to select repeat. Press to choose from
WEEKLY, DAILY, MON-FRI, MON-SAT or NO.
8. Press to select subtitles. Press to choose YES or NO.
9. When the details are correct, press [OK] to store
them.
10. To exit menu, press [QUIT].
If a mistake has been made during DETAIL ENTRY, an error message will be displayed at the
bottom of the screen. For instance, in the event of 2 programmes being entered with similar
start times, then an EVENT CLASH error message will be displayed. If any errors are found
during this stage, the system will not allow any further progress.
When the Timer Event has been activated, both RED and GREEN LEDs will be lit for the duration
of the event. A suitably equipped VCR will record automatically during this time. Please note
that unless your VCR supports automatic scart recording YOU MUST ALSO SET THE VCR TIMER.
In order to delete an entry you no longer need, position the cursor over the entry to be removed
in the TIMER PROGRAMMING menu and press [RED].
Cancel an event at any time by pressing [QUIT]. Press [QUIT] again to confirm.
Use
▼
▲
//
