TIE DOWN PENETRATOR User manual

Penetrator and Roof Zone Cart
Assembly Instructions
Important – Please Read These Instructions Fully Before Starting Assembly
Step 1
Pull from this side
Position the Cart and Penetrator as close as possible
to the final assembly. Stand up the Penetrator on its
extension arm and safety plate.
Step 2
Pull the Penetrator device under the cart from the
opposite side of the cart. Stop pulling when the
pull pin stop is aligned with the cart.
Step 3
From the weight side of the Penetrator, lift up on
the pull pin mounting bracket. Align the holes with
the Penetrator and the pull cart. Insert the pull pin
through the bracket and cart. Attach safety pin
to the pull pin.
When you open the Penetrator Fall Protection
device for the first time, some minor assembly
will be required. The Penetrator device is shipped
as shown to the right. The front guard plate, cleats and
cart assembly must be assembled before use.
Instruction Sheet #08264 (E1449 Rev. 3-7-2016)
030716,E1449

Anchor Shackles
with Pins
Step 4
From the front side of the Penetrator, lift up on
the pull pin mounting bracket. Align the holes with
the Penetrator and the roof cart. Insert the pull pin
through the bracket and cart. Attach safety pin
to the pull pin.
Step 5
Locate the 5/8“ Hex Head Bolt and
5/8” nylock nut from the hardware bag.
Working from the front side of the Penetrator,
Align the front guard plate to the top right
mounting hole located on the Penetrator base.
Insert the hex head bolt through the base and
front guard plate, attach nylock nut. Tighten
with a 5/8” wrench. The front guard plate
must be able to pivot outward without
any resistance (Do not over tighten).
Step 6
Locate the 5 anchor shackles from the
hardware bag.
Working from the front side of the Penetrator,
install the two anchor shackles for fall restraint
on top position holes. Install the remaining three
anchor shakles on the fall arrest arm in front
of the front guard plate.
Step 7
Carefully lift and place the ballast weights
one at a time on the ballast slide assembly.
BE VERY CAREFUL, THESE ARE PITCH POINTS
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com [phone] Fax [phone]