3
www.topvehicletech.com
FITTING GUIDE
1. Open the passenger side door and proceed to pull away the door trim from the pillar.
STEREO REMOVAL
DAB ANTENNA INSTALLATION
2. Using a set of panel removal tools, begin to pry away the pillar casing.
4. The DAB antenna not only has a self adhesive backing, but also features a black earth sheet. When
placing the DAB antenna, the earth sheet MUST be placed onto the metal part of the pillar. The antenna
itself must be located roughly 15cm from the top of the windscreen.
Note: this antenna must not be placed atop any kind of heang elements, this will interfere with the
antenna’s signal.
5. Once happy with the placement, take the 3m of wiring extension and feed it down through to the
stereo’s opening. With the wiring adjusted to the appropriate length, feel free to re-install the glovebox.
3. The glovebox will need to be opened/removed to route the antennas wiring. You will need to remove
the side panel as well as the inside pocket so that you can transfer the wiring easily.
1. Using a bojo tool on either side, pry away and remove the air vents from the dashboard, disconnecng
the hazard switch wiring in the process.
2. Remove the 2x screws that secure the main display and remove this whilst disconnecng the wiring.
FASCIA PLATE SET-UP
1. Take the OEM climate control panel and begin to unclip both the automac air con unit as well as the
lower buon panel. Once removed, these can then be transferred directly into the relevant openings
found on the new fascia and top pocket.
3. Now remove the 2x screws that hold the climate control panel in place. Once removed, use a bojo tool
to release the whole assembly, again, disconnecng all the wiring in the process.
5. When happy with the alignment, and the “Stereo Installaon” process is complete, screw the stereo
into the dashboard using the pre-exisng screws. Then simply clip down the fascia over top. Following this,
place the the top pocket and screw into place.
4. Aach the brackets to the new stereo using the screws within the kit. With the brackets aached, oer
the whole unit to the back of the fascia and test t within the vehicle to gauge the correct depth.
3. Finally, undo the 2x screws that hold the main radio in place and remove whilst disconnecng all the
wiring.
2. Take the clips from the OEM fascia panel, and relocate them onto the new fascia panel where required.
3. Aach the relocaon mount clips within the clip and aach them using the screws within
the kit to the boom le and right corners of the new top pocket (see image for orientaon).L R
