3
www.topvehicletech.com
๎ฆ๎ฏ๎ค๎ค๎ฏ๎
๎ง๎๎ง๎จ๎ฏ๎๎
๎๎ค๎๎๎๎๎๎๎๎๎๎ณ๎๎พ
๎ฆ๎๎๎๎ฏ๎๎๎๎พ๎๎ค๎๎๎๎๎ค๎ฅณ๎จ๎
1. Use a panel removal tool to release the plas๎c trim that surrounds the main display and air vents.
2. With the brackets now a๎ฉached to the fascia plate, proceed to feed the new stereo in between the
brackets. Adjust in accordance to the front of the fascia panel and screw into place with the provided 4x
๎at ended bolts.
3. Once the โStereo Installa๎onโ process is complete, push the stereo into the dashboard, and complete
the installa๎on by placing the original fascia trim over top and reassembling the dashboard in reverse
order.
2. Using a set of radio release keys (or a pick tool), undo the 4x spring clips holding the main display into
place and remove it completely whilst disconnec๎ng all of the wiring.
1. Using the 4x phillips screws within the kit, a๎ฉach the brackets to the appropriate sides of the new fascia
plate.
3. Again, using a set of radio release keys (or a pick tool), head into the glovebox and undo the 2x spring
clips holding the main head unit into place and remove it completely whilst disconnec๎ng all of the wiring.
Note: at this point, any/all wiring will need to be re-directed over to the main display aperture, ready
for the installa๎on of the new head unit.
7. A๎ฉach the antenna adapter to the vehicles pre-exis๎ng connec๎on and the back of new stereo.
2. Take the steering wheel control interface and a๎ฉach the 14-way steering wheel harness connector to
the relevant side.
STEREO INSTALLATION
3. Make a cut within the orange and purple loops on the back of the patch lead connector. Then proceed
to a๎ฉach โKey 1โ to the light blue โSWC Remoteโ wire on the stereo. When done, connect the 12-way
connector to the steering wheel control interface.
4. A๎ฉach the 4-way camera extension harness to the steering wheel control interface.
5. Connect the male yellow RCA to the โreverse camera inputโ on the back of the new stereo.
1. Take the interface and set the dipswitches accordingly (note that these are default to o๎ซ):
ON (DOWN) OFF (UP)
DIPSWITCH 1 Pioneer head units All other head units ๎ฅพ๎๎๎จ๎๎ต๎ฏ๎๎ฅฟ
DIPSWITCH 2 Reverse Camera PAL Reverse Camera NTSC ๎ฅพ๎๎๎จ๎๎ต๎ฏ๎๎ฅฟ
DIPSWITCH 3 Reset factory se๎ซngs (switch) Reset factory se๎ซngs ๎ฅพ๎๎๎จ๎๎ต๎ฏ๎๎ฅฟ
DIPSWITCH 4 Not Used Not Used
6. Connect the a๎ermarket reverse camera (if required) to the female yellow RCA on the camera extension
harness.
Note: ensure the โCamera Connectedโ op๎on in the โPreferencesโ menu is set to โYesโ for the camera to
func๎on correctly.
