
–2 –
EN
Art. No. User Manual: 104840 – Rev. D, 2022-01
EN
SV
3 Unfolding / Folding
Unfolding: Release the lock clamp posi-
tioned at the seat bars (A). Press the seat
bars down and outwards. The side frames
will slide apart. Press down the seat bars
(B). You will hear a clicking sound. The
rollator is now locked in its open position.
Folding: Pull the strap on the seat (C) and
press the side frames together. Lock the
clamp (D) over the seat bars.
Carrying the rollator: The rollator must
not be carried by the seat strap or the
brake cables.
Fold the rollator together as shown on the
illustration (E). Carry the rollator by the
seat bars (F) when folded.
4 Handles / Memory function
Height adjusting: Untighten the lock
wheel (A) (approx. 2 turns). Adjust the
handle tubes to a suitable height then
pull them slightly up and down (C) until
you hear a clicking sound. Tighten the
lock wheel (A) again. Adjust both handles
to the same height by comparing the
number scale on each side. It is recom-
mended that the handles are set to the same
height as your wrists when your arms are
hanging alongside your body.
Memory Function: Decide on the height
of the handles (see number scale). Count
visible holes at the back of the handle
tubes. Unscrew the lock wheel (A). Pull the
tube (B) out of the frame. The fastening
piece (D) will now follow the handle tube.
Move the fastening piece (D) so that the
number of holes above it equals to the
previously counted holes. Fit the red
memory chip (E) on the handle tube in
the rst available hole under the fastening
piece (D). Push the handle tube (B) and
the fastening piece (D) downwards and
into the side frame (F). Screw the lock
wheel (A) halfway in. Pull the handle (G)
up until it stops, and then tighten the lock
wheel (A) properly. From now on, when
the handle is in the lowest position, it will
stop in the pre-set position when pulled
up.
5 Brakes
Make sure the brakes are working before
each trip. Each brake lever (A) works on
each of the rear wheels. Do not drive or
push the rollator while the parking brakes
are in use.
Parking brakes: Push both brake levers
(A) downwards until they lock. Both rear
wheels are now locked. Squeeze both
brake levers upwards to release the park-
ing brakes.
Driving brakes: Pull both brake levers
(B) upwards to reduce speed. Do not use
continuously while the rollator is in motion.
Adjusting / checking: Loosen the nut
(C). Tighten the brake cable (D) with the
adjustment screw (E). Adjust both brake
blocks so the distance to the wheel sur-
face is approximately 1 mm (F) and then
tighten the nut (C). Make sure the brakes
are not adjusted too tight and pressing
hard into the rubber of the wheels when
the parking brake is on.
Maintaining: Clean the brake block (F)
and the brake spring (G) frequently. The
wheels and brakes can be replaced if they
are worn out or damaged.
6 Seat
The rollator has a safe and convenient
mesh seat, which provides view to the
ground while walking. It can easily be
wiped with a cloth if needed. The parking
brakes must be activated before using the
seat. Push both brake levers downwards
until they lock (A). Both rear wheels are
now locked. Sit with your back towards
the basket (B).
7 Edge guard /Tilt function
Edge guard: The edge guards (A), which
are in front of the rear wheels prevent
the rear wheels from catching on corners,
door frames etc.
Tilt function: To use the tilt function use
the front of the foot and press down on
the tilt pedal (B), which is beside the rear
wheel. This helps to tilt the rollator over
thresholds, edges etc. Please note: Take
care when descending kerbs.
Basket
The basket holds up to 10 kilos (model M
& S) / 5 kilos (model X). It can be removed
and washed gently at up to 60°C.
Transport
The rollator should be transported in the
folded and locked position (see paragraph
3 Unfolding / Folding). Ensure that the lock
clamp is on, so that the rollator cannot
unfold unintentionally. Be careful when
loading the rollator into a vehicle, giving
attention to securing it.
Storage
The rollator should be stored in an upright
position. If stored outdoors it must be
under a cover to protect it. Do not leave
your rollator unattended. Do not put
heavy items on top of the rollator during
storage.
Cleaning
The rollator can be hosed and washed
with normal household detergents.
Machine washing in the dish cabinet used
at aid centres can be used (washing; 60°C,
10min. – drying; 70°C, 10min.). Do not use
abrasives. Avoid ushing directly against
bearings (wheels, front forks).
TOPRO Troja Original