Tork SS721Z Installation manual

FOR TECHNICAL SUPPORT: SOUTIEN TECHNIQUE : PARA COMUNICARSE CON EL SERVICIO TÉCNICO: [email protected] 877.230.7874 LI-835
A DIVISION OF NSi INDUSTRIES, LLC
PROGRAMMING INSTRUCTIONS
SS721Z
SS721ZA
CAUTION
Before wiring and servicing, power
to this time switch and the equipment
it controls must be turned off at the
main panel.
WARNING
Unit must be properly grounded to
operate correctly.
RATINGS
• 120/277VAC 16A 1920/4432W Resistive
• 120/277VAC 13A 1560/3600VA Ballast
• 120VAC 8A 960W Tungsten
• 120VAC 1 HP
SS721Z SMART TIMER
INSTALLATION
1. Connect black and blue wires as shown in the diagram.
Cap the red wire.
2. Connect the mounting strap green wire and timer green
wire to the ground wire.
3. Mount the timer inside electrical box using 2 mounting
screws provided.
4. Install cover plate.
5. Turn power on at the electrical panel.
RETROFITTING A SS721Z
TO EXISTING 3-WAY SWITCH
1. Disconnect the second 3-way switch.
2. Connect the timer blue wire to the load. Connect the timer
black wire to “Traveler A” and the timer red wire to
“Traveler B”.
3. Connect the mounting strap green wire and timer green
wire to the ground wire.
4. Mount the timer inside electrical box using 2 mounting
screws provided.
5. At switch #1 connect a wire between the hot leg of the
3-way and “Traveler A” inside of that switch’s gang-box.
6. Install cover plates.
7. Turn power on at the electrical panel.

1.0 Press MODE to go to the CLK mode.
2.0 TO SET CLOCK
3.0 TO SET DATE
4.0 TO SET AUTOMATIC DAYLIGHT
SAVING TIME ADJUSTMENT
5.0 DAYLIGHT SAVINGS MODE CONFIRMATION
6.0 SCHEDULE SET MODE
a) For automatic sunset ON/sunrise OFF press MODE and go to step 7
b) For sunset ON & time OFF, press ENTER and go to step 6.2 to set OFF time
then go to step 7.
c) To set an ON/OFF time go to step 6.1
6.1 SETTING AN ON TIME
6.2 SETTING AN OFF TIME
6.3 NEXT SCHEDULE
Repeat steps 6.1 & 6.2 for additional ON/OFF pairs OR
MODE
HOUR MIN ENTER
ENTER OR
To skip
ENTER
DAY
MAINE
VT
NH
MASS
NEW YORK
PENNSYLVANIA
OHIO
IND
ILLINOIS
KENTUCKY VIRGINIA
NORTH CAROLINATENNESSEE
WEST
VIRGINIA
SOUTH
CAROLINA
GEORGIAALABAMA
MISS
FLORIDA
LOUISIANA
ARKANSAS
OKLAHOMA
MISSOURI
TEXAS
KANSAS
NEW MEXICO
MEXICO
ARIZONA
CALIFORNIA
NEVADA UTAH COLORADO
NEBRASKA
WYOMING
IDAHO
OREGON
SOUTH DAKOTA
IOWA
WISCONSIN
MICHIGAN
MINN
NORTH DAKOTA
MONTANA
WASHINGTON
RHODE ISLAND
CONNECTICUT
NEW JERSEY
MARYLAND
DELAWARE
45°
50°
60° ALASKA
40°
35°
30°
25°
ASTRONOMIC LATITUDE ZONES
ZONES DE LATITUDE
ZONAS ASTRONOMICAS (LATITUDES)
21° HA W AII 18° PUERTO
RICO
MODE
ENTER
34
OR
To skip LAT
HOUR MIN ENTER
DAY
HOUR MIN ENTER
DAY
INSTALLATION INSTRUCTIONS
SS721Z
SS721ZA
PLEASE READ ALL INSTRUCTIONS FIRST
When rst powered-up or after pressing reset button the unit will display the word “HOLd” and a 30 second
countdown will begin. The display will then ash “SS700” and show “12:00am.” The unit is ready for programming.
FOR TECHNICAL SUPPORT: SOUTIEN TECHNIQUE : PARA COMUNICARSE CON EL SERVICIO TÉCNICO: [email protected] 877.230.7874 LI-835
A DIVISION OF NSi INDUSTRIES, LLC
HOUR MIN ENTER
ENTER
YEAR
DATE
MONTH
MODE
7.0 TO SET AUTOMATIC DAILY
SUNSET/SUNRISE (ASTRO) SCHEDULE
See map below. Find desired degree of latitude from 10° to 60° north.
Use LAT key to advance. If the screen reads LAtS it is for south hemisphere.
Advance to N.
7.1 SET SUNSET ON
Press DAY to show today’s sunset time.
7.2 OPTIONAL OFFSET
Turn load ON before or after calculated sunset
7.3 SET SUNRISE OFF
Press DAY to show today’s sunrise time.
ENTER
DAY
7.4 OPTIONAL OFFSET
Turn load OFF before or after calculated sunrise
8.0 AUTO (AUTOMATIC) MODE
9.0 MAN (MANUAL) MODE
HOUR MIN ENTER
ENTER
OR
To skip
Pour passer
Para ignorar
NOTE: Press HOUR to move from after sunrise (“AF”) to before sunrise (“bF”)
MODE
34
NOTE: AUTO mode will follow the programmed schedule. OVERRIDE sets
ON/OFF until the next event.
NOTE: Press RND to put unit in optional random mode. ON events will be
delayed up to 30 minutes and the OFF events will be delayed up to 45 minutes.
NOTE: MAN mode will bypass programmed schedule. OVERRIDE set ON/OFF
until next OVERRIDE push
NOTE: Press RESET to clear time and date. To clear all press ENTER, press
DEL, then ENTER again.
MODE
To skip
ENTER ENTER ENTER ENTER
OR MODE
MODE