Toro 22306 User manual

Controls Overview
Traction control Loader arm/attachment tilt lever
Parking brake
lever
Auxiliary hydraulics lever
(Attachment operation
lever)
Throttle lever
Choke lever Key switch
Fuel gauge Hour meter
Oil warning light
(TX425 only)
Reference bar
Loader arm lock
Part No. 106–5713

Starting the Engine
1. Move the throttle
lever between Fast and
Slow.
2. Move the Choke
lever to On.
3. Turn the
ignition key
to Start until
the engine
starts.
4. Gradually move
the choke lever to
Off.
5. Adjust the throttle
lever as desired.
Driving
m–7019
Forward Reverse
Neutral/Stop
Turn Right Turn Left

Stopping the Engine
1. Move the throttle
lever to Slow. 2. Lower the loader
arms.
3. Turn the ignition
key to Stop. 4. Remove the ignition
key.
m–6564/6569/6568
Operating Tips
m–7040
Carry loads as low as possible.
On slopes or when loading onto a
trailer, keep the heavy end uphill. With
no attachment, an empty bucket, or
another light attachment the back is
the heavy end; with a full bucket or a
hydraulic attachment, the front is the
heavy end.

Connecting an Attachment
m–6571
1. 2.
Connecting Hydraulics
1. Stop the
engine. 2. Slowly cycle the hydraulics lever 3 times. 3. Release the hydraulics lever into
Neutral.
3X
4. Clean the couplers and then
push the attachment hydraulic
couplers into the couplers on the
traction unit.
3. Ensure that
the pins are
engaged in the
holes in the
attachment
mounting
plate.

Operating the Hydraulics
Disconnecting Hydraulics
m–6566/6570
1. Stop the
engine. 2. Slowly cycle the hydraulics
lever
3 times.
3. Release
the hydraulics
lever into
Neutral.
3X
4. Pull back the collar on the female hydraulic
couplers and pull the attachment couplers from
the traction unit couplers.
Place the caps
over the traction
unit couplers.
Forward
Reverse
Neutral

Loading the Traction Unit on a Trailer
m–6573
1. Load the traction unit onto the trailer with the
heavy end uphill.
3. Secure the
traction unit
with chains or
straps.
2. Set the parking brake.