Toro ECXTRA Operating instructions

- 1 -
ECXtra (Green) Programming Shortcuts
*** MUST HAVE THE APPROPRIATE NUMBER OF MODULES IN TO BE ABLE TO
PROGRAM THIS TIMER (Example: 4 zones equals 2 modules). ***

- 2 -
A. SETTING THE TIME AND DATE
TURN THE DIAL TO SET TIME/DATE
•HOURS SHOULD FLASH
•ADJUST HOUR WITH THE +/- BUTTONS
•PRESS THE NEXT BUTTON
•MINUTES SHOULD FLASH
•ADJUST MINUTES WITH THE +/- BUTTONS
•PRESS THE NEXT BUTTON
•DAYS SHOULD FLASH
•ADJUST DAYS WITH THE +/- BUTTONS
•PRESS THE NEXT BUTTON
TURN DIAL TO AUTO/ON
B. SETTING THE PROGRAM START TIMES
TURN THE DIAL TO PROGRAM START TIME
•START TIME #1 SHOULD FLASH
•PRESS THE NEXT BUTTON
•HOURS SHOULD FLASH
•ADJUST HOUR WITH THE +/- BUTTONS
•PRESS THE NEXT BUTTON
•MINUTES SHOULD FLASH
•ADJUST MINUTES WITH THE +/- BUTTONS
•PRESS THE NEXT BUTTON
*START TIME #2 WILL FLASH. IF AN ADDITIONAL START TIME IS
NEEDED, REPEAT THE STEPS ABOVE.
C. SETTING THE VALVE RUN TIMES
TURN THE DIAL TO VALVE RUN TIME
•VALVE #1 SHOULD FLASH
•PRESS THE NEXT BUTTON
•RUN TIMES SHOULD FLASH
•ADJUST MINUTES WITH THE +/- BUTTONS
•PRESS THE NEXT BUTTON
*VALVE #2 SHOULD FLASH. REPEAT THE STEPS ABOVE FOR EACH
ADDITIONAL VALVE TO BE PROGRAMMED.

- 3 -
D. SETTING THE WATERING DAYS
TURN THE DIAL TO SET WATERING DAYS
•CAL SHOULD FLASH
•PRESS THE NEXT BUTTON
•USING THE +/- BUTTONS, SELECT OR DELETE DAYS FOR
WATERING
•-(+) IS USED TO SELECT
•-(-) IS USED TO DELETE
**WHEN SUNDAY FLASHES AGAIN, PRESS THE NEXT BUTTON
E. TURN DIAL TO AUTO/RUN
INTERVAL WATERING (OPTIONAL) ODD/EVEN DAYS
•WHEN CAL FLASHES, PRESS THE (+) BUTTON
•INT SHOULD FLASH
•PRESS THE NEXT BUTTON
•ADJUST THE PROPER INTERVAL SETTING USING THE +/-
BUTTONS
•PRESS THE NEXT BUTTON
•DAY SHOULD FLASH
•USING THE (+) BUTTON, SELECT THE DAY TO START
INTERVAL
*USE “PROGRAMS” SLIDE SWITCH TO CREATE ADDITIONAL PROGRAMS.
REPEAT STEPS B, C, D, AND E ABOVE.
F. Clear Program Memory
To clear the memory
•Turn the dial to the off position.
•Press “+” and “-“button at the same time.
G. Replacement Parts
Module 53714
¾ Amp Fuse 363-5026
Transformer 363-3514B
NOTE: ALL THRE PROGRAMS (A, B, & C) WILL RUN EVERY DAY
REGARDLESS OF SLIDE SWITCH POSITION. TO PREVENT A PROGRAM
FROM RUNNING, IT MUST BE TURNED OFF UTILIZING THE “START TIMES”
FEATURE.