TownSteel E-GENIUS 2000 Series User manual

TOWNSTEEL
E-GENIUS 2000 SERIES
LOCK INSTALLATION
5 1/2” CENTER TO CENTER

HANDING INFORMATION
INTERCONNECT LOCK IS HANDED. SEE HANDING INFORMATION BELOW.
HANDING INFORMATION FROM OUTSIDE
IF HANDING NEEDS TO BE CHANGED, SEE CHANGING HANDING (PAGE 21).
5
IF HINGES ARE ON THE LEFT,
AND DOOR OPENS INWARD,
IT IS A LEFT HAND DOOR(LH)
IF HINGES ARE ON THE LEFT,
AND DOOR OPENS OUTWARD,
IT IS A LEFT HAND REVERSE DOOR(LHR)
IF HINGES ARE ON THE RIGHT,
AND DOOR OPENS INWARD,
IT IS A RIGHT HAND DOOR(RH)
IF HINGES ARE ON THE RIGHT,
AND DOOR OPENS OUTWARD,
IT IS A RIGHT HAND REVERSE DOOR(LHR)

DOOR PREPARATION
PREPARE DOOR AND JAMB PER TEMPLATE PROVIDED. BACKSET IS ADJUSTABLE
FOR 2 3/4” OR 2 3/8”. BACKSET IS DIMENSION FROM EDGE OF THE DOOR TO
CENTERLINE OF LOCK.
IMPORTANT:
DOOR SDOOR STOP IS WHERE
DOOR WILL STOP WHEN
NORMALLY OPERATED.
STOP INCLUDES ANY
GASKET, SMOKE SEAL, OR
BUMPERS. POSITION OF
STRIKES ARE TO BE
MEASURED FROM WHERE MEASURED FROM WHERE
DOOR ACTUALLY STOPS.
DEADBOLT, WHEN
THROWN, CANNOT HAVE
ANY INTERFERENCE WITH
DEADBOLT STRIKE. IF
THERE IS ANY
INTERFERENCE, STRIKES INTERFERENCE, STRIKES
NEED TO BE ADJUSTED
FOR LOCK TO WORK
PROPERLY.
6
BACKSET
5 1/2”
DOOR STOP
DOOR JAMB

STEP 1
ADJUST LATCH BOLT BY ADJUSTING HUB.
7
TO ADJUST FROM 2 3/8” TO 2 3/4”, ROTATE HUB ON THE DIAGONAL AS SHOWN
BELOW. PULL HUB TO THE LEFT. PUSH HUB TO THE RIGHT TO GO BACK TO 2 3/8”.
HUB
2 3/4”2 3/8”