Toyota Avensis 2006 TNS600 User manual

Model year: 2006
Vehicle code: **T25*R-*****W
Part number: • Navigation System PZ 445-00331-00
• Audio Frame 55405-05160
Manual ref. no: AIM 000 766-1
Avensis
TNS600
RHD installation instructions

Avensis (T25) TNS 600
Avensis (RHD) - 201-07
PRECAUTIONS
• Do not pinch the rear wiring or
harness in the tightened part.
PLEASE READ THOROUGHLY THESE PRECAUTIONS BEFORE THE INSTALLATION
• Be sure to disconnect the negative
(-) lead from the battery terminals.
• When passing the wires through the
dashboard or other panels, use a
grommet to ensure waterproofing.
• Protect the wiring with tape when it
is passed through a hole.
• When disconnecting the connectors,
be sure to grip the connector body.
Do not tug on the wiring.
• Do not forcibly pull any car wiring
harness. Rough tugging may result
in opened connections, or a broken
wire or harness.
• Confirm that lamps, horn, wiper and
other car accessories operate normally.
• Protect your car with fender cov-
ers, seat and so on.
• Use the correct tool when tight-
ening bolts or nuts.
• Before drilling a hole, check
that the rear of the mounting
wall is clear.
• Be sure to firmly tighten connec-
tors and terminals.
• Before connecting the power
wiring to the battery, check the
wiring connections, harness,
etc. to see that they are properly
secured.
• Check body and trim near area of installation to be certain no
dirt or scratches resulted from the installation.
Stop it !
Waterproof - O.K. !!
Grommet
Taping
Insert completely

Avensis (T25) TNS 600
Avensis (RHD) - 301-07
Precautions ............................................................................................................................................. 2
Component parts ................................................................................................................................... 4
Navigation Kit ........................................................................................................................................ 5
How to connect ..................................................................................................................................... 6
Installation Overview .............................................................................................................................. 7
Vehicle Disassembly ................................................................................................................................ 8
Installation of the GPS-Antenna .............................................................................................................. 10
Wire Harness Installation ......................................................................................................................... 12
Installation of the Navigation Disc .......................................................................................................... 17
Post-Installation Inspection ..................................................................................................................... 17
Reassembling ......................................................................................................................................... 17
Be sure to read the General Installation Instructions (Common Section) before installing
TNS 600.
REMARK
TABLE OF CONTENTS

Avensis (T25) TNS 600
Avensis (RHD) - 401-07
Avensis (T25) TNS 600
AUDIO DISPLAY TILT OPEN
MENU
SEEK
TRACK
DEST
MAP
VOICE
DISC
TUNE
VOICE NAVIGATION
PWR•VOL
TA
INFO
FM
AM
B-9001
TOYOTA
1 2 3
46
7 8
5
NODescription Qty
1TNS600 1
2WIRE HARNESS 1
3GPS ANTENNA 1
4NAVIGATION DISC 1
5WIRE CLAMP 2
6FOAM TAPE 2 + 3
7WIRE TIE 10
8EARTH PLATE 1
COMPONENT PARTS PZ445-00331-00

Avensis (T25) TNS 600
Avensis (RHD) - 501-07
Avensis (T25) TNS 600
OWNER’S MANUAL
To be ordered separately.
Refer to ATA database for partnumbers
COMPONENT PARTS 55405-05160

Avensis (T25) TNS 600
Avensis (RHD) - 601-07
Avensis (T25) TNS 600
Refer to the repair manual for information on removal of vehicle parts, installation methods, tightening
torque etc.
Vehicle wire harness
Splicing connector
(Reverse sensor wire)
Antenna wire
GPS antenna
3
5P
TNS 600 Tuner with LCD Display
8P
10P 6P
Splicing connector
(Speed sensor wire)
HOW TO CONNECT

Avensis (T25) TNS 600
Avensis (RHD) - 701-07
GPS antenna
Antenna wire
Splicing connector (Speed reverse Sensor with pre wire)
Splicing connector (Reverse Sensor without pre wire)
Splicing connector (Speed Sensor without pre wire)
INSTALLATION OVERVIEW

Avensis (T25) TNS 600
Avensis (RHD) - 801-07
1
2
1.
a) Remove the gear lever knob .
1.
b) Remove the gear lever hole cover .
: Clip (4x)
2
1
FOR M/T MODELS
Fig. 2
Fig. 1
3
2. Remove the instrument panel cluster
moulding .
: Clip (5x)
3
FOR ALL MODELS
Fig. 3
3. Remove the heater control assembly .
: Bolt (4x)
104
7
7
104
VEHICLE DISASSEMBLY

Avensis (T25) TNS 600
Avensis (RHD) - 901-07
Fig. 4
4. Remove the storage box .
: Screw (2x)
: Clip (2x)
105
8
8
105

Avensis (T25) TNS 600
Avensis (RHD) - 1001-07
Fig. 5
12x
1. Cut the foam (d) into 12 pieces as
shown in the illustration.
A
A
(d)
Fig. 6
2.
a) Remove the release paper of the earth
plate and attach the butyl tape as
shown.
b) Apply the tapes to the adhesive side
of the earth plate .
10
11
11
10
11
10
INSTALLATION OF THE GPS-ANTENNA
3.
a) Attach the earth plate to the air
duct as shown and mount the GPS-
antenna to the earth plate .
b) Attach the antenna wire using the
foam tapes (3x).
8
3
10
3
8
10
Fig. 7
8
8
3
10
Centre
When affixing the earth plate make
sure to carefully wipe of any dirt,
moisture or oil from the surface of the
location where it is to be affixed.
10
CAUTION

Avensis (T25) TNS 600
Avensis (RHD) - 11 01-07
Fig. 8
4. Route the GPS antenna wire as
shown.
3
3

Avensis (T25) TNS 600
Avensis (RHD) - 1201-07
Pliers
Splicing connector
Vehicle wire harness
Fig. 9
a) Remove the vinyl tube or wrapping
tape from the length of vehicle wire
harness to be connected.
b) Insert the vehicle wire harness to
beconnected securely into the guide
slit.
c) After inserting the vehicle wire harness
into the guide slit, lock the splicing
connector securely using a pair of pliers
or the equivalent until the connector
clicks.
CONNECTING PROCEDURES OF
SPLICING CONNECTOR
Fig. 10
Fig. 11
WIRE SIDE VIEW
23
1. Disconnect the female 18P connector
of the vehicle wire harness as
shown.
28
23
3
28
29
28
WIRE SIDE VIEW
FOR MODELS WITH PRE-WIRE
23
4
9
WIRE HARNESS INSTALLATION
2.
a) Connect the female 18P connector of
the wire harness to the vehicle wire
harness male 18p connector .
b) Attach the wire harness and GPS-
antenna wire to the vehicle wire har-
ness using a wire tie .
: Wire tie (2x)
9
9
29
3
4
28
4

Avensis (T25) TNS 600
Avensis (RHD) - 13 01-07
3. Cut the red/white wire away and
isolate .
2
1
Fig. 12
FOR VEHICLES WITHOUT PRE-WIRE
Fig. 13
1. Route the reverse sensor wire as
shown in the illustration.
2
20P (white)
10P (white)
2
Fig. 14
2. Connect the speed sensor wire
(Violet/White) to terminal 3 of the
20P (White) connector.
2
20P (white) Tab
Splicing connector
Speed sensor wire
20P Wire side vieuw

Avensis (T25) TNS 600
Avensis (RHD) - 1401-07
Fig. 15
3.
a) Route the reverse sensor wire as
shown in the illustration.
b) Disconnect the 18P (White) connector.
2
Fig. 17
Fig. 16
4. Connect the reverse sensor wire (Green)
to terminal 8 f the 18P (White) con-
nector.
2
5.
a) Reconnect the 18P (White) connector.
b) Secure the reverse sensor wire as
show in the illustration using the foam
tape.
2
Recerse sensor wire
18P (white) Tab
Splicing connector
18P Wire side vieuw
Foam tape x 6
Recerse sensor wire (Green)
Vehicle Wire Harness Recerse sensor wire
Foam tape
18P (white)
18P (white)

Avensis (T25) TNS 600
Avensis (RHD) - 15 01-07
Fig. 18
6. Secure the excess speed sensor wire
and reverse sensor wire as shown in
the illustration using the foam tape .
8
2
Foam tape x 2
Speed sensor wire
Recerse sensor wire
7. Remove the speed signal from 20 pin
connector (pin 3)
Fig. 19
R
8. Removed the left and right side brack-
ets from the unit.
Fig. 20

Avensis (T25) TNS 600
Avensis (RHD) - 1601-07
MODE
AUTO DUAL
A/C OFF
TEMP
TEMP
10.
a) Slight (put) the frame on the airco and
mount the brackets on the TNS600 and
the airco.
b) Connect the connectors and place the
headunit back in place.
Fig. 22
R
11. Reassemble the brackets on the head
unit.
Fig. 23
PWR•VOL
AM/FM
TUNER
AUDIO CONTROL
SEEK
TRACK
AST
PTY TA
AF
TXT
123456
TAPE/DISC
TEMP
AUTO
DUAL
A/C
MODE
OFF
TEMP
Fig. 21
9. Slight the airco to the left to disassem-
le the airco.

Avensis (T25) TNS 600
Avensis (RHD) - 17 01-07
MODE
AUTO DUAL
A/C OFF
TEMP
AUDIO DISPLAY TILT OPEN
MENU
SEEK
TRACK
DEST
MAP
VOICE
DISC
TUNE
VOICE NAVIGATION
PWR•VOL
TA
INFO
FM
AM
B-9001
TOYOTA
TEMP
12. Re fit all parts.
Fig. 24
ENSURE THAT ALL REMOVED CONNECTORS ARE PUT BACK CORRECTLY.
REFIT THE TRIM AND REMOVED PARTS.

Avensis (T25) TNS 600
Avensis (RHD) - 1801-07
Fig. 22
MAP
DISC
CAUTION NOTICE
CLOSE
Be careful not to injure
your fingers when opening
Do not place any objects on the panel
Do not leave the panel open when it is
DVD-ROM INSERTION INTO
THE NAVIGATION ECU
INSTALLATION
1. Connect the battery and turn the igni-
tion switch to the ACC position.
2. Press open.
3. With the label side of the disc facing up,
insert the Navigation Disc into the disc
insertion slot.
* The disc will be pulled into the
computer automatically.
4. Press close.
INSTALLATION OF NAVIGATION DISC
Installation Check
1. Inspect the wiring and installation for abnormalities.
2. Check particularly closely for any locations where the vehicle harness, wire harness or divergency harness is being
pushed, pulled or pinched using excessive force. Also check again that clamps and bands have not shifted out of
position and that all parts have been tightened.
Operation Check
1. Attach the (-) terminal of the battery and turn the key to the ACC or ON position or start the engine.
2. Press the NAVI switch and confirm that the navigation screen is displayed.
3. Adjust the volume by following the section on ”Adjusting the Volume of the Guide Voice” in the TNS600 Owner’s
Manual, and confirm that the sound from the speakers changes.
4. Perform the “auto-compensation” procedure by following the section on “When Tires are Replaced” in the
TNS600 Owner’s Manual.
When an abnormality is suspected, perform troubleshooting based on the “Toyota Genuine Navigation System Service
Manual”.
POST-INSTALLATION INSPECTION
Return all vehicle parts that have been removed to their original locations. Especially make sure to attach trim
and other interior materials properly so that they do not have a detrimental effect on the function of the vehi-
cle. During restoration, make sure that wires are not pinched and all bolts and screws are tightened.
REASSEMBLING

GENUINE PARTS