TP-Link Omada EAP615 User manual

User Guide
For TP-Link Omada Access Points
© 2023 TP-Link 1910013169 REV4.8.0
Note: Unless otherwise noted, the introduction in this guide takes EAP650 as an example. Features available in the EAP may vary by model.

I
CONTENTS
About This User Guide........................................................................................................ 1
Overview ................................................................................................................................. 3
1 Quick Start....................................................................................................................... 4
1.1 Determine the Management Method.................................................................................................. 5
1.2 Connect Network Devices...................................................................................................................... 6
1.3 Log in to the EAP and Change the SSID............................................................................................. 8
1.4 Configure and Manage the EAP..........................................................................................................21
2 Configure the Network.............................................................................................. 22
2.1 Configure the Wireless Parameters..................................................................................................24
2.1.1 Configure SSIDs .............................................................................................................................. 25
2.1.2 Configure Wireless Advanced Settings ................................................................................. 32
Radio Setting.................................................................................................................................... 32
Load Balance.................................................................................................................................... 34
Airtime Fairness .............................................................................................................................. 34
More Settings .................................................................................................................................. 35
2.1.3 Configure the MLO Network (Only for Wi-Fi 7 Devices) ................................................... 37
2.2 Configure Portal Authentication ........................................................................................................39
Configure Portal............................................................................................................................................ 40
Configure Free Authentication Policy .................................................................................................. 46
2.3 Configure VLAN........................................................................................................................................49
2.4 Configure MAC Filtering........................................................................................................................50
2.5 Configure Scheduler...............................................................................................................................53
2.6 Configure Band Steering.......................................................................................................................56
2.7 Configure QoS...........................................................................................................................................57
2.8 Configure Rogue AP Detection...........................................................................................................61
Detect Rogue APs and Move the Rogue APs to the Trusted AP List....................................... 62

II
Manage the Trusted AP List..................................................................................................................... 63
2.9 Configure Smart Antenna (Only for Certain Devices).................................................................65
3 Monitor the Network ..................................................................................................66
3.1 Monitor the EAP........................................................................................................................................67
3.2 Monitor the Wireless Parameters......................................................................................................69
Monitor the SSIDs........................................................................................................................................ 70
Monitor the Radio Settings....................................................................................................................... 71
Monitor Radio Traffic .................................................................................................................................. 71
Monitor LAN Traffic ..................................................................................................................................... 72
3.3 Monitor the Clients..................................................................................................................................74
View Client Information.............................................................................................................................. 74
View Block Client Information ................................................................................................................. 76
4 Manage the EAP...........................................................................................................77
4.1 Manage the IP Address of the EAP....................................................................................................78
4.2 Manage System Logs .............................................................................................................................81
View System Logs ....................................................................................................................................... 81
Configure the Way of Receiving Logs.................................................................................................. 82
4.3 Configure Web Server............................................................................................................................84
4.4 Configure Management Access.........................................................................................................85
Configure Access MAC Management.................................................................................................. 85
Configure Management VLAN ................................................................................................................ 86
4.5 Configure Trunk (Only for Certain Devices)...................................................................................87
4.6 Configure LED ...........................................................................................................................................88
4.7 Configure Wi-Fi Control (Only for Certain Devices)....................................................................89
4.8 Configure PoE Out (Only for Certain Devices) ..............................................................................90
4.9 Configure SSH...........................................................................................................................................91
4.10 Configure SNMP.......................................................................................................................................92
4.11 Configure Power Saving (Only for Certain Devices) ...................................................................94

III
5 Configure the System................................................................................................ 95
5.1 Configure the User Account ................................................................................................................96
5.2 Controller Settings..................................................................................................................................97
Enable Cloud-Based Controller Management .................................................................................. 97
Configure Controller Inform URL ........................................................................................................... 99
5.3 Configure the System Time............................................................................................................... 100
Configure the System Time ...................................................................................................................101
Configure Daylight Saving Time...........................................................................................................103
5.4 Reboot and Reset the EAP................................................................................................................. 105
5.5 Backup and Restore the Configuration......................................................................................... 106
5.6 Update the Firmware ........................................................................................................................... 107
6 Application Example ............................................................................................... 108
6.1 Determine the Network Requirements ......................................................................................... 109
6.2 Build the Network Topology.............................................................................................................. 110
6.3 Log in to the EAP ................................................................................................................................... 111
6.4 Configure the EAP ................................................................................................................................ 112
Configure SSIDs .........................................................................................................................................112
Configure Portal Authentication...........................................................................................................113
Configure Scheduler.................................................................................................................................115
6.5 Test the Network................................................................................................................................... 117

1
About This User Guide
When using this guide, notice that features available in the EAP may vary by model and software
version. Availability of the EAP may also vary by region or ISP. All images, steps, and descriptions in
this guide are only examples and may not reflect your actual experience.
Some models featured in this guide may be unavailable in your country or region. For local sales
information, visit
https://www.tp-link.com .
The information in this document is subject to change without notice. Every effort has been made
in the preparation of this document to ensure the accuracy of the contents, but all statements,
information, and recommendations in this document do not constitute the warranty of any kind,
express or implied. Users must take full responsibility for their application of any product.
Conventions
Unless otherwise noted, the introduction in this guide takes EAP245 as an example.
Wireless Speed and Range Disclaimer
Maximum wireless transmission rates are the physical rates derived from IEEE Standard 802.11
specifications. Range and coverage specifications were defined according to test results
under normal usage conditions. Actual wireless transmission rate and wireless coverageare not
guaranteed, and will vary as a result of 1) environmental factors, including building materials,
physical objects and obstacles, 2) network conditions, including local interference, volume and
density of traffic, product location, network complexity, and network overhead and 3) client
limitations, including rated performance, location, connection quality, and client condition.
Ethernet Port Limitation Disclaimer
Actual network speed may be limited by the rate of the product’s Ethernet WAN or LAN port, the
rate supported by the network cable, Internet service provider factors and other environmental
conditions.
Wireless Client Capacity Disclaimer
Wireless client capacity specifications were defined according to test results under normal
usage conditions. Actual wireless client capacity is not guaranteed, and will vary as a result of 1)
environmental factors, including building materials, physical objects and obstacles, 2) network
conditions, including local interference, volume and density of traffic, product location, network
complexity, and network overhead and 3) client limitations, including rated performance, location,
connection quality, and client condition.
MU-MIMO Disclaimer (for EAPs that support MU-MIMO)

2
MU-MIMO capability requires client devices that also support MU-MIMO.
Seamless Roaming Disclaimer (for EAPs that support Seamless Roaming)
Seamless roaming requires both the access point and client devices to support 802.11k and
802.11v protocols.
Lightning and Electro-Static Discharge Protection Disclaimer (for Outdoor EAPs)
Protection against lightning and electro-static discharge may be achieved through proper product
setup, grounding and cable shielding. Refer to the instruction manual and consult an IT professional
to assist with setting up this product.
More Info
Some models featured in this guide may be unavailable in your country or region. For local sales
information, visit
https://www.tp-link.com .
For technical support, latest software, and management app, visit
https://www.tp-link.com/support .
The Quick Installation Guide can be found where you find this guide or inside the package of the
EAP.
The authentication information can be found where you find this guide.
Specifications can be found on the product page at
https://www.tp-link.com .
To ask questions, find answers, and communicate with TP-Link users or engineers, please visit
https://community.tp-link.com to join TP-Link Community.
If you have any suggestions or needs on the product guides, welcome to email
[email protected] .

3
Overview
Omada series products provide wireless coverage solutions for small-medium business and
households. They can either work independently as standalone APs or be centrally managed
by Omada Software Controller, Omada Hardware Controller, or Omada Cloud-Based Controller,
providing a flexible, richly-functional but easily configured wireless network for small-medium
business and households.

4
1
Quick Start
This chapter introduces how to build a wireless network using the EAPs and how to
complete the basic settings. Follow the steps below:
1.1 Determine the Management Method
1.2 Connect Network Devices
1.3 Log in to the EAP and Change the SSID
1.4 Configure and Manage the EAP

5
1.1 Determine the Management Method
Before building your network, choose a proper method to manage your EAPs. You have
the following two options:
■ Controller Mode
If you want to manage a large-scale network centrally, choose Controller Mode. In
Controller Mode, you can configure and monitor mass EAPs, switches, and gateways via
Omada SDN Controller. For detailed instructions, go to the Support Webpage of Omada
Controller and download the User Guide.
■ Standalone Mode
If you want to manage only a few EAPs, choose Standalone Mode. In Standalone Mode,
you can singly configure and monitor your EAPs via Omada APP or a web browser, and
each EAP has its own management page.
This chapter introduces how to start configuring the EAP in Standalone Mode.
Note:
•Standalone Mode is inaccessible while the EAP is managed by a controller. To turn the EAP back
to Standalone Mode, you can forget the EAP on the controller or reset the EAP.
•To make your EAPs discovered by the controller, you need to configure
5.2 Controller Settings
in certain scenarios.

6
1.2 Connect Network Devices
To connect your EAPs to the local network, refer to the following topology.
In
ternet
Clients
Router (DHCP Server)
WANLAN
EAP
EAP
1. Connect the WAN port (or Internet port) of the router to the internet.
2. Connect your EAPs to the LAN port of the router.
3. Connect your wireless clients such as phones, tablets and laptops to the WiFi of the
EAP. The default SSID is printed at the bottom of the EAP.
Now you can surf the internet on your phones, tablets and laptops. If you cannot access
the internet, follow the FAQ to troubleshoot the problem.