TP-Link TL-WA801ND Manual

The TP-Link TL-WA801ND is a multi-function access point. This document is intended to assist with
configuring the TL-WA801ND to allow the EG3000 to communicate on an existing WiFi network.
This guide is designed only for use with a TP-WA801ND purchased through eGauge Systems
For full documentation and other support issues, please visit the TP-Link website athttp://www.tp-
link.com/. The full TP-Link manual as of the writing of this article is available here. Please visit TP-
Links website for the most up to date information.
1. Attach the included two antennas to the back of the access point. Ensure the connections
are not loose.
2. Power the TP-Link TL-WA801ND using the barrel jack or PoE (Power-over-Ethernet)
injector, and connect a computer to the access point using an Ethernet cable (if using the
PoE injector, connect the LAN port to your computer, and the POE port to the access
point).
3. Ensure all wireless interfaces are disabled on the computer (such as WiFi and Bluetooth)
and that DHCP is enabled on the Ethernet interface. Open a web browser and access the
TL-801ND by visiting
http://tplinkap.net/
4. Log in using usernameadminand passwordadminand chooseLogin.
5. ClickQuick Setupfrom the left side, thenNext.
6. Change the admin password if desired and chooseNext.
7. ChooseClientas the operation mode and pressNext.
TP-Link Access Point Setup
(TL-WA801ND)
Configuration instructions


8. Find your wireless network, and chooseConnect.
9. Enter the wireless network password and choose Next.

10. If DHCP service is on the wireless network, leave the Type asSmart IP (DHCP)and
chooseNext.


11. Verify the settings that are chosen, and choose Finish.
The access point has been configured and the eGauge may be connected via Ethernet for network
communication.

I cannot reach the eGauge on the proxy server or locally.
Verify the TP-Link access point is powered up and configured. Connect a laptop to the Ethernet
port on the TP-Link access point, disable WiFi, bluetooth and any other wireless network interfaces
and try reaching the internet.
I don't see my network listed in the quick setup network list, or the signal is weak or
inconsistent.
Ensure the two antennas are secured on the back of the unit and that the wireless network is
within range of the access point.
I do not have network access through the TP-Link access point, or the network information
has changed and I cannot access the configuration interface.
Perform a factory reset on the TP-Link access point by using a paperclip or pin and holding down
the recessed reset button on the back of the unit, release the button when all the LEDs turn off or
flash. Then, re-configure the unit using the steps in this article.
Troubleshooting
Revision #2
Created Fri, Jan 31, 2020 10:15 PM by Andrew

Updated Wed, Mar 4, 2020 7:57 PM by Andrew