Assembling the Transcend 365 miniCPAP™
1. Connect your mask (sold seperately) to an air supply tube with a standard
22mm connector.
2. Connect the air supply tube directly to the Transcend 365 miniCPAP device,
making sure it is fully seated.
3. Connect the water reservoir to the device. Ensure that the silicone seal is not
folded over or knocked loose while connecting.
4. Plug the power supply into the Transcend 365 miniCPAP and place on a at,
stable surface.
5. Connect the power supply to a wall outlet.
Automatic Ramp
The ramp feature is enabled on your CPAP, unless your prescription states
otherwise.
Mask Settings
Be sure to set your device with the appropriate mask settings before you use
it for the rst time. This helps reduce the risk of mask leakage and ensures the
correct amount of humidity is delivered during therapy. See the Transcend 365
miniCPAP Quick Guide for instructions.
365 User Tips:
• Never move the device with water in the reservoir. First remove the device
from the reservoir then transport the device and reservoir separate.
• Place reservoir down on a at surface and then place the 365 device on top,
ensuring the silicone seal is not folded over or knocked loose.
• If storing for an extended period of time, allow device to fully dry before
packing. This can take up to 24 hours.
• If the reservoir is not fully dry prior to transport, place in a Ziplock bag to
prevent any water from damaging the CPAP.
The Transcend 365 User Manual
can be downloaded at
www.MyTranscend.com/
support
400212 REV C
Press
centerbutton
to begin
therapy
