Transition Networks SISTM1040-262D-LRT-B Operating and maintenance instructions

SISTM1040-262D-LRT-B Quick Start Guide
Package Contents
•SISTM1040-262D-LRT-B Hardened 18 Port Switch
•Wall Mount Bracket
•Quick Start Guide
•Console DB-9 to RJ45 Cable
•6-Pin Terminal Block Power Connector
Redundant Power Inputs
The switch has two 12-48VDC power inputs, power input 1 and
power input 2. Positive and negative terminals are labeled V+ and
V- for each input. Note polarity on the chassis of the switch.
Suitable wire sizes to use for the power connection are
12~22AWG. 16AWG or 18AWG is preferred. Connect wires
between the + terminals on the power supply and the +terminals
on the switch terminal block. Do the same with the –terminals.
Maintain correct polarity. Ensure the screws are tight and the
wires secure.
Chassis Ground
There is a chassis ground screw that can be used to ground the
device enclosure. Only negative grounding should be used.

Device Configuration
The SISTM1040-262D-LRT-B switch can be controlled via a built-in web server which supports Internet
Explorer (IE 5.0 or above versions) and other Web browsers such as FireFox and Chrome. Note: By default,
IE5.0 or later version do not allow Java applets to open sockets. You must modify the browser setting
separately in order to enable Java applets for network ports.
Management via Web Browser
Default values:
IP Address: 192.168.1.77
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254
1. Launch your Web browser.
2. Type http://192.168.1.77 into the address bar
and press Enter. The login screen displays.
3. Type in Username: root Password: root.
4. Click Enter or OK button.
The main management page displays.
Basic Settings/IP Settings – Set IP Address:
You can enable DHCP by checking the box to
automatically obtain an IP address, or manually enter
static IP address information. Click Apply and the new
values will be applied and displayed.
Reset to Factory Defaults
On the front of the device, under the console port is a
hole to access the reset button. Use a paper clip to
press and hold the reset button for 5 seconds. The
LEDs on the switch will flash and the setting will be
returned to factory defaults.
For more information contact Transition Networks at:
800.526-9267 or visit us online: www.transition.com.