TONE is a unique control that lets you cut back on the high frequencies. It’s
perfect when you’re looking for a mellower, more vintage sound.
The REGEN (short for “regeneration”) knob is used in anger mode to adjust
the amount of feedback you get. Turn it up for that unmistakably weird feed-
back ange.
The CHORUS/FLANGER button is where you switch between the two twister
eects. For a warm vintage sound, turn down Regen to a minimum and use it
in Flanger mode. It will go from a smooth ange to an extreme “rubber band”
eect.
Note: the INPUT LEVEL knob on the side of your Twister 2 eliminates overdrive
distortion caused by too high an input signal. Keep it set just below where the
red light comes on.
STEREO OUT
Twister 2 features a stereo output so you can take advantage of all the glory of
stereo chorus/ange when you’re in the studio or running a stereo live setup.
If you think Twister 2 sounds great in mono, try running it in stereo. It will blow
your mind!
TECHNICAL SPECIFICATIONS
Input Impedance@1KHz Higher than 1M ohm
Output Impedance@1KHZ Lower than 1K ohm
Power supply 9V DC (T-Rex FuelTank)
Minimum Power supply Voltage 8,5V DC
Maximum Power supply Voltage 12,5V DC
Current Draw @ 9V DC 85 mA
Maximum Input signal Vp/p Adjustable
External connectors Input Jack, Output Jack, 9V DC
Jack
Battery Type & Battery Life 9V battery 6F22 - 30 to 60 min.
Controls On/Off, Input Gain, Level, Depth,
Regen, Speed, Tone and Chorus/
Flanger
Pedal size incl. knobs (W x H x D) 100 x 55 x 120 mm
3,9 x 2,2 x 4,7 inch
Weight
(excl. battery and packaging) 0,350 kg / 12,3 oz