© 2017 TRINITY - 800.985.5506
ASSEMBLY INSTRUCTIONS
STEP 3: INSTALLING SHELF (LIP DOWN)
STEP 2: SLIP SLEEVES
* For safety and stability, the lowest SHELF (E) should be lower than the 3rd notch from the bottom.
** Note: There will be a very small gap in-between the SLIP SLEEVES (I)—this is normal.
3
A (4) I (8)
For easiest assembly, do not attach the TOP (B) and
BOTTOM (A) POLES until instructed. Once connected,
these will be the posts for the Cart.
Note that each POLE (A+B) has slight horizontal line
indentations at 1” intervals. Each SLIP SLEEVE (I) has
raised horizontal lines inside designed to lock them in
place on the POLE (A+B).
On the BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (I)
at the desired level. Please make sure the arrow faces up
and that the word “TOP” is right side up. Do this for each
BOTTOM POLE (A) and make sure that the heights are
identical for BOTTOM POLE (A).
Slide the pair of SLIP SLEEVES (I) until you hear a click to
confirm the pair is locked onto the BOTTOM POLE (A). DO
NOT place more than one pair on each POLE (A+B) at a
time.
Place SHELF LIP DOWN (E) on its side and slide the (4)
BOTTOM POLES (A) through the holes in the SHELF LIP
DOWN (E). Make sure that the SHELF (E) corner cylinders
are positioned over the SLIP SLEEVES (I).
Stand the unit upright.
*Note: The level side of the SHELF (E) is the TOP side (the
TRINITY logo on the corner cylinders should be right-side
up).
**Use a rubber mallet, if needed, to secure the SHELF (E).
E (1)
