Trojan Telecom DBT 1000 User manual

REF: DBT1000230908
Ist Floor
Amphenol Complex
Thanet Way
Whitstable
Kent
CT5 3JF
ENGLAND
Tel: (+44) (0)1227 275357 Fax: (+44) (0)1227 272932
e-mail: [email protected]
USER GUIDE
DBT 1000
ww r ntel.c.w .t ojao uk

1. INSTALLATION
2. OPERATION
2.1 Follow On
2.2 Redial Button
2.3 RingerPitchSetup
2.4 RingerVolumeSetup
2.5 ReceiverVolumeControl
2.6 MuteButton
2.7 Modem Socket
2.8 PauseButton
2.9 RecallButton
2.10 MessageWaiting
2.11 Hear-aidcompatibility
3. APPROVEDUSE
4. CE APPROVED
5. NUMBER OF PHONES THAT CAN BE CONNECTED
6. WARRANTY
Contents
The layout of your DBT 1000
1
ABC 2
1DEF 3
JKL 5 GHI 4MNO6
TUV 8 PQRS7WXYZ9
0
MUTE
REDAIL
VOLUME
RECALL
PAUSE
RING PITCH
FOLLOW-ON
Park Hook
Follow-on button
Ringer Pitch Button
Pause Button
Recall Button
Redial Button
Volume Control Buttons
Mute Button
With LED Indication
Ring Indicator/
Message Waiting
Indication
Wall Mount
Tab

3
1. INSTALLATION
Connectoneendofthecoilcordtothehandsetandtheother
end to the handset socket located on the left hand side of the
phone.Replacethehandsettothecradle.
Connect the small plug of the telephone line cord to the
socket at the back of the unit and the other plug to the
telephonesocketatthewall.
After connecting the telephone to the line socket, the
handsetshouldbeliftedtocheckdialtoneisbeingreceived.
The DBT 1000 telephone is supplied with the mounting
bracketfixedinthewallmountposition. Fordeskpurposes,
you should remove the bracket and then replace in the
reverseposition.
2. OPERATION
2.1FollowOn
During a call you can press the 'Follow On' button to
disconnect the call and obtain dial tone. This allows you to
set up a new call without having to replace the handset into
thephonebase.
Installation & Operation
2
Operation
2.2RedialButton
Ifyoudialanumberandfinditisengagedorthereisnoreply,
replace the handset. The number will be retained in the
memoryuntilyoudialadifferentnumber.
Whattodo: Liftthehandset
PresstheREDIALbutton
2.3RingerPitchSetup
There are three options for the ringer pitch setting and they
are programmed as follows:
1. Lift the handset
2. Press '3'(Slow Ring), '6' (Normal Ring) or '9' (Fast Ring)
on the keypad
3. Replace the handset
2.4 Ringer Volume Setup
The ringer volume on the telephone can be set by the
switch located on the right hand side of the telephone.
Set the switch to either High, Low or OFF.
NOTE: When the ringer volume is set to OFF, the ringer
indication will still flash to show that the phone is ringing.
2.5 Receiver Volume Control
Thereceivevolume canbeadjustedUPorDownbypressing
the two volume control buttons. The phone will remember
thelastvolumesettingwhenmakinganewcall.
2.6MuteButton
During a conversation the microphone on the telephone
handset can be muted by pressing the MUTE button. The
LEDwill flash to indicate that the muteis on. To turn off the
mutefacility,pressthemutebuttonagain.
MW1 SELECT
2 1 OFF
RINGER
OFFLOWHI
Message
Waiting Ringer
Volume

5
2.7ModemSocket
On the rear of the telephone there is a modem socket which
allowstheconnectionofaPCModem,Faxmachineorother
telephone device. The phone handset needs to be in the
cradleforthePCModemorFaxmachinetousethissocket.
2.8PauseButton
Pressing the PAUSE button during dialling will put a 2
second pause in the dialling sequence. This is needed on
some telephone systems where you may be required to dial
anaccesscodetoobtainalinebeforediallingyournumber.
2.9RecallButton
If you are connected to a telephone system the RECALL
Operation
4
Approved Use & Warranty
3. APPROVEDUSE
The DBT 1000 can be connected to the Public Switched
Telephone Network (PSTN) and compatible to PABX's but
not connected in the following manner: -
1. As an extension to a payphone.
2. On shared service line or 1+1 carrier system.
NetworkCompatibility
The DBT 1000 has been approved persuant to
European harmonized standards:
Health & Safety:
EN60950-1:2001 (+A11:2004)
EN50371:2002
Electromagnetic Compatibility:
EN55022:2006 emissions
EN55024:1998 + A1:2001 immunity.
Telecom:
ES 203021 Parts 1, 2 & 3
TBR38
4. THE NUMBER OF TELEPHONES THAT MAY
BE CONNECTED
If you connect too many telephones to your line they may
not ring correctly. To determine the number of telephones
that can be satisfactorily connected to your line, add
together the ringer equivalent numbers (RENs) of all the
equipment you wish to connect. If this number exceeds
four, your telephones may not ring. Your DBT 1000
telephone has an REN of one (1). BT telephones have an
REN of one unless otherwise marked.
5. WARRANTY
Trojan Telecom has built the DBT 1000 telephone to a high
standard. Our warranty reflects our belief that during it’s
working life you should not experience any mechanical
failures.
Trojan Telecom will at all times use a sensible and
supportive attitude towards warrantable returns, working
with you in identifying ‘no fault found’.
The following terms and conditions apply:
1) Where we find a genuine warranty failure, Trojan
Telecom will replace the faulty instrument with a one-for-
one replacement.
button is used for transferring calls or accessing other
systemfeatures.
On a normal telephone line the RECALL button may be
used for select services supplied by the telephone line
provider.
2.10MessageWaiting
The DBT 1000 telephone is designed to work with many
analoguePBXtelephonesystemsthatuseeither90VorLine
Reversal message waiting signalling. The MWI switch is
locatedontherighthandsideofthephone.
OFF-Thissetting should beusedwhena constantvoltageis
sentbythetelephonesystemtoindicateamessageiswaiting
(90Vsystem).
1 - This setting should be used when the system supplies a
linereversal toindicatethat amessageis waiting. In normal
usetheMWILEDshouldbeoff.
2 - If the MWI LED is on in normal operation, set the switch
toposition2.
2.11 Hear-aidcompatibility
Thehandsetreceiverishearingaidcompatible.
MODEM LINE
Modem
Socket Line
Socket

7
2) It is the responsibility of the user to return the faulty
telephone to Trojan Telecom. We ask you to cover this
cost and we will return your replacement telephone at our
expense.
3) We reserve the right to repair the faulty item or replace
it with a similar telephone of the same make.
4) Discontinued models under warranty will be replaced
with a similar or more featured telephone.
5) We reserve the right to charge for items considered to
be chargeable under fair wear and tear.
6) User misuse or any modification carried out to the DBT
telephone by the customer is not considered a
manufacturing fault or component defect. Therefore it is
not covered by the warranty.
7) Accidental damage such as liquid spillage or user
damage will not be covered under the terms of the
warranty.
8) When returning the telephone please ensure you fully
complete the returns authorisation form, failure to do so
could cause you unnecessary delay.
Warranty
6
The terms of this warranty do not effect your statutory
rights.
Warranty applies to UK customers only.
Faulty units should be returned to our service centre at the
following address, together with the completed return
form on the opposite page.
SERVISCOMM
UNIT 2, RED BARNES WAY
McMullen Road, Darlington
DL1 2RR UK