Truma VarioHeat User manual

Product information
Truma VarioHeat and E-Kit
July 2018

2
Truma CP plus VarioHeat − iNet ready*
iNet-capable appliances can be controlled and monitored
with the digital control panel. The ergonomic design and
intuitive operation simplify adjustment of the desired
functions.
•Intuitive operation: With a practical rotary push button
from the automotive sector
•Large display: With background lighting on which the
symbols are also clearly readable at night
•Power saving mode: Lighting can be switched off in
two levels if functions are not being used
Truma VarioHeat eco and Truma VarioHeat comfort are of
an identical size, but have a different output. The compact
design enables both variants to be installed flexibly in the
vehicle without losing any storage space.
Truma VarioHeat
The new compact Truma heaters for motor homes,
caravans and vans.
Truma VarioHeat
•Light: Weighs just 5.5 kg
•Time-saving: Simple and flexible installation
•Troubleshooting capability: Simply read out the fault
memory with the Truma Diagnose Tool
•Extendable: The Truma E-Kit can also be added
The Truma E-Kit supplements the Truma VarioHeat with an
electric heater. Both appliances are controlled via the
Truma CP plus
VarioHeat control panel or the Truma App.
* Detailed information can be found in the Truma iNet System product
info in the dealer Login at www.truma.com.
Can be extended with the TrumaiNet Box*
With this it is also possible to control and monitor TIN bus-
capable appliances via the Truma App.
Truma E-Kit
•Practical: Simple to retrofit
•Variable: Can be installed upright and horizontally
•Networked: Easy to integrate into the Truma iNet
System
Variants VarioHeat
•Truma VarioHeat eco
•Truma VarioHeat comfort
•Electric heater: Truma E-Kit
Truma E-Kit dates
Series start August 2018

heating | cooling | controlling 3
Function
Truma VarioHeat
The Truma VarioHeat is a warm air heater for air circulation
to heat camping vehicles quickly in gas mode.
•Fan-supported burner: Ensures that operation is
problem-free, even when on the move.
•Automatic fan level selection: According to the
temperature difference between the room temperature
set on the control panel and the current room
temperature. This appliance always starts up at the
lowest setting. If this is not sufficient to achieve the
desired temperature inside the vehicle, the appliance
switches to a higher operating level after about
5minutes.
•Circulation air mode: can be selected with or without
heating mode in various ventilation levels
Truma E-Kit
The Truma E-Kit is installed in addition to the Truma
VarioHeat. Heating is possible in gas, electrical or mixed
mode with this combination.
•Electrical mode: Only the Truma E-Kit is used for
heating in the 900 or 1800 W operating levels.
Warm air distribution is via the Truma VarioHeat.
•Mixed mode: Start in gas mode, electrical mode is
activated. A total output of 4600 W is achieved in
combination with the Truma VarioHeat eco, and 5500 W
is achieved with the Truma VarioHeat comfort.
Truma CP plus VarioHeat digital control panel
The Truma CPplus VarioHeat control panel is used to
control and monitor a Truma VarioHeat heater (with or
without Truma E-Kit) and / or a Truma air conditioning
system.
•Room temperature: Individually adjustable
•Timer function: Programming of the connected iNet-
capable appliances, e.g. night-time reduction, automatic
climate control
•Fan levels: Individually adjustable circulation air mode
•Auto: Heating power is automatically regulated
•Night mode: for an uninterrupted peaceful night
•Boost: for very quick heating
•Additional functions with Truma E-Kit: Electric mode
and mixed mode

4
Truma VarioHeat installation
To achieve even heating of the vehicle, it must be ensured
that the heater is installed in the vehicle as centrally as
possible.
30 - max. 150 cm
30 - max. 150 cm
30 - 150 cm
max.
30 cm
The mounting brackets enable the Truma VarioHeat to be
easily installed in various installation positions.
4
2
2
1
1
3
4
3
2
1
Wall cowl kits
Two wall cowl kits are available: for wall thicknesses up to
20 mm (EW 24) and up to 40mm (64 L).
Warm air distribution
The heater routes the warm air either directly or via flexible
ducts mainly in the floor of the living compartment.
≤ 100 cm
VR 80
Truma VarioHeat eco
Truma VarioHeat comfort
Y 80 ÜR
ÜR
VR 80
≤ 100 cm
≤ 50 cm
Y 80 ÜR
ÜR
ÜR Y
ÜR
Gas connector
The 30 mbar operating pressure of the gas supply must
correspond to the appliance’s operating pressure (see type
plate).
Power supply
The 12 V connector cable is connected to the electronics
of the Truma VarioHeat.
Room temperature sensor
The provided room temperature sensor must always be
connected, otherwise the heater will switch to fault
.
Truma CP plus VarioHeat
Lay the connector cable (TIN bus) to the heater and if
necessary to the air conditioning system, and plug in on
the Truma CP plus VarioHeat control panel.
Plug in the 12 V connector cable and connect to an
unswitched 12 V operating voltage (permanent positive).
Attention
None of the connector cables may be longer than 10 m.
The installation instructions provided with the appliance
must be observed.

heating | cooling | controlling 5
Truma E-Kit installation
The Truma E-Kit can be added directly to the heater or in-
tegrated into the warm air distribution. The maximum total
duct length of the VR 80 (including Truma E-Kit) is 100cm.
Truma E-Kit
VR 80
Truma E-Kit
Truma E-Kit
VR 80 VR 80
≤ 100 cm
ÜR
ÜR
Y 80
The Truma E-Kit is secured to the floor or wall with a
mounting bracket (included in the scope of delivery).
The duct adapter (optional) is required for installation into
the Ø80 mm warm air distribution. Only the duct VR 80*
or the elbow BG 80 may be plugged into this.
Truma E-Kit
E-Kit
Ø 80 mm
BG 80
Truma E-Kit
Power supply
The Truma E-Kit is connected to both the 12 V power
supply and the 230V supply.
Control unit connection
The Truma E-Kit is plugged into the TIN distributor (2)
with the TIN connecting cable (1).
E-Kit
1
2
Attention
None of the connector cables may be longer than 10 m.
The installation instructions provided with the appliance
must be observed.
* Part numbers can be found in the current dealership catalogue and
in Truma Parts in the dealership Login
at www.truma.com.

6
Technical data
Truma VarioHeat eco Truma VarioHeat comfort Truma E-Kit
Rated thermal output Level 1 1 300 W
Level 2 2 800 W
Level 1 1 300 W
Level 2 2 800 W
Level 3 3 700 W
Level 1 900 W
Level 2 1800 W
Air delivery volume Level 1 75 m³/h
Level 2 155 m³/h
Level 1 75 m³/h
Level 2 155 m³/h
Level 3 210 m³/h
−
Gas consumption (propane/butane) Level 1 100 g/h
Level 2 220 g/h
Level 1 100 g/h
Level 2 220 g/h
Level 3 290 g/h
−
Power consumption (12 V) Level 1 0.65 A
Level 2 2.75 A
Level 1 0.65 A
Level 2 2.75 A
Level 3 5.4 A
approx. 0.15 A
Power consumption (230 V) − − Level 1 3.9 A
Level 2 7.8 A
Quiescent current, heater
with Truma CP plus VarioHeat 0.004 A 0.004 A
−
Weight
Heater without periphery 5.5 kg 5.5 kg
2.2 kg
The Truma E-Kit is only approved for the Truma VarioHeat. It must not be used while on the move.
all dimensions in mm
Dimensions
123
380
248
Truma E-Kit
190
260 123

heating | cooling | controlling 7
Part numbers
Product Part No. Description
Truma VarioHeat
with Truma CPplus VarioHeat control panel, cable length 6m, room temperature
sensor, installation bracket and accessories for the electrical connection
37401-01 Truma VarioHeat eco
37501-01 Truma VarioHeat comfort
39200-01 Truma E-Kit
with mounting bracket and connection cable
39630-01 Duct adapter
39492-01 Elbow BG
Wall cowl kits must be ordered separately
The part numbers for the wall cowl kits and other accessories can be found in the current dealers’ catalogue or in Truma
Parts in the dealer Login at www.truma.com.

EN - Fo
Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Straße 12
85640 Putzbrunn
Germany
Telefon [phone]
[e-mail] The right to effect technical modifications is reserved!
Handel
MAT 19.07.2018 Truma VarioHeat & E-Kit