U-Line HEX H-2560 User manual

PAGE 1 OF 2 0213 IH-2560
πH-2560
HEX PICNIC TABLE
1-800-295-5510
uline.com
1. Loosely attach the 6 anchor blocks to the bottom of
the 6 seats with the 3½" lag screws and washers with
the socket. The bored hole on the block faces the
side with three edges. (See Figure 1)
2. Place the 3 support arms on a flat level surface in a
fan pattern. Using the 3" deck screws, loosely attach
the support arms together. Use 2 deck screws per
side. (See Figure 2)
Power Drill (Or Screw Gun)
7/16" Socket Wrench
ASSEMBLY
PARTS
TOOLS NEEDED
Base x 3 Anchor Block x 6
3½" Lag Screw x 302½" Lag Screw x 6Support Arm x 3 3" Deck Screw x 6 Washer x 36
Tabletop x 1Right Seat x 3Left Seat x 3
Figure 2
Figure 1

PAGE 2 OF 2 0213 IH-2560
ASSEMBLY CONTINUED
Figure 4 Figure 7
Figure 6
Figure 5
Figure 3
3. Loosely attach the pre-drilled holes of the seat to
the pre-drilled holes of the support arms using 12 of
the 3½" lag screws and 12 washers with the socket.
(See Figure 3)
4. Position the seat assembly approximately 10-15" off
the floor. A five gallon bucket under the center works
well. (See Figure 4)
5. Insert the three bases under each set of seats.
Center each leg to the counter-bored holes in the
seat. (See Figure 5)
6. Use the 2½" lag screws to loosely attach base to the
seat. Use a tape measure to ensure that the seat is
centered. Should be 2" from base. Make sure the
seat is pressed flat against the base. (See Figure 6)
7. Place the tabletop on top of table to align with the
pre-drilled holes of the base. Make sure the support
arms are centered. (See Figure 7)
8. Loosely attach each base to the tabletop and
arms using the 3½" lag screws and washers with the
socket.
9. Make sure the table is squared and tighten all lag
and deck screws
WARNING! Do not lean on tabletop or seats
when assembling.
NOTE: H-2565 Mounting hardware sold
separately.
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com