Underwater Lights USA sea vision SV18 User manual

Underwater Lights USA, LLC Underwater Lights Europe Sarl
3406 SW 26th Terrace, C-6/7 2323, Chemin de Saint-Bernard
Fort Lauderdale, FL 33312 USA Space Antipolis 6, 06220 Vallauris, France
Phone: [phone] Phone: [phone]
Fax: [phone] Fax: [phone]
Internet: www.seavision.com Internet: www.seavision.com
Email: [e-mail] DOC:092305-1 Email: [e-mail]
Introduction:
Congratulations on the purchase of your new three color (Red, Green, Blue) LED light driver box. Underwater Lights®USA, LLC
takes pride in providing well designed, high quality and thoroughly tested lights that allow you to “enhance your boating
experience”. These lights can be installed in your vessel for aesthetics, to attract fish, for security and safety.
Features Include:
Latest DMX control technology and electronic component construction to guarantee high levels of performance.
Universal VAC input with short circuit, over current, over voltage and over temperature protections.
Electrical wiring terminal blocks and VAC input fused protection.
General Safety Information:
This driver box is specifically designed for use with matching Underwater Lights®USA, LLC brand LED lights only.
Always ensure that VAC power is disconnected and locked out before performing driver box installation and/or service.
The driver box should be opened and visually inspected every six months.
Driver box electrical cabling should be visually inspected for proper operating condition every six months.
Technical Specifications:
Box Dimensions = 260mm (10.2”) long x 160mm (6.3”) wide x 91mm (3.6”) deep - 3.5 kilograms (7.7 pounds)
Box Construction = Gray painted diecast aluminum alloy with polyurethane gasket, IP66/NEMA 4X rated
Driver = 100-277 VAC 50/60 Hz - RGB: 0.55 Amps 120V, 0.30 Amps 230V - 264W - Minimum operating temperature -30°C (-22°F)
Power Cable to Driver Box = Marine grade electrical cable, 16/3 stranded copper wire, with as short a length as possible
Cable from DMX Control to Driver Box = Marine grade electrical cable, shielded 18/3 stranded copper wire is recommended
Driver Box Cable to LED Light = Marine grade electrical cable, 18/4 stranded copper wire, 5 meters (16 feet) maximum length
Terminal Block Fuse = Fast blow 10 Amp cylindrical, 6.3mm diameter x 25mm or 32mm long (0.25” diameter x 1.0” or 1.25” long)
Troubleshooting:
Please contact our technical support staff in Florida at 1-954-760-4447, Monday to Friday from 8:00 am to 5:00 pm EST.
Warranty:
Underwater Lights®USA, LLC warrants this driver box to be free from defects in workmanship and materials for a period of two
years from the date of original purchase. Further, misuse, abuse, improper installation, neglect, improper shipping, damage caused
by disasters such as fire, flood and lightning, unauthorized repair or modifications will void said warranty. Should your driver box
prove defective during the warranty period, promptly contact Underwater Lights®USA, LLC for an RMA number and then return the
driver box freight prepaid with the RMA number clearly marked on the outside of the shipping container.
SV18 RGB LED Driver Box
120-230VAC

Underwater Lights USA, LLC Underwater Lights Europe Sarl
3406 SW 26th Terrace, C-6/7 2323, Chemin de Saint-Bernard
Fort Lauderdale, FL 33312 USA Space Antipolis 6, 06220 Vallauris, France
Phone: [phone] Phone: [phone]
Fax: [phone] Fax: [phone]
Internet: www.seavision.com Internet: www.seavision.com
Email: [e-mail] DOC:092305-1 Email: [e-mail]
MODEL 12N33R-60, 120-230VAC
BALLOON PART DESCRIPTION
1 18042 ENCLOSURE
2 18035 MOUNTING PLATE
3 18003 TERMINAL BLOCK MOUNT
4 18043 FUSED TERMINAL BLOCK
5 18044 CABLE STRAIN RELIEF
6 18045 CABLE STRAIN RELIEF
7 18046 BLANKING PLUG
8 18047 RGB LED DRIVER*
9 18011 M3.5 x 0.6 x 12LG PPHS
10 18013 FAST BLOW FUSE
11 18031 M4 x 0.7 x 6LG SST PPHS
12 18009 M6 x 1.0 x 8LG SST PPHS
13 18039 SURGE PROTECTION DEVICE*
14 18010 M4 x 0.7 x 8LG SST PPHS
15 18049 3-POLE TERMINAL STRIP
16 18050 4-POLE TERMINAL STRIP
*PLEASE CALL FOR OTHER PRODUCT COMPONENT CONFIGURATIONS
120-230VAC
Installation:
The driver box should be mounted in a cool, dry, well ventilated and easily accessible location. Attach the driver box to a fixed
bulkhead or similar secure structure using appropriate M6 fasteners with adequate space between driver boxes for proper cooling.
Note: Whereas the driver box can be placed in any orientation, it is recommended that the cable strain reliefs face down.
Using marine grade cable, run a VAC input line into the driver box and secure using one large cable strain relief. Run cable from
supplied RGB LED Light and shielded DMX cable/s to the driver box and secure by way of remaining cable strain reliefs. Note:
Since the DMX Out cable is an optional feature, it may not exist. Caution! Avoid making tight bends and/or passing cables over
sharp edges/surfaces. Connect cable wire leads inside the driver box per wiring diagram below.
Serviceable Parts:
Upon opening the driver box by unscrewing four captive lid fasteners, replacement of RGB LED driver, surge protection device or
fused terminal block is accomplished by removal and replacement of associated fasteners and wiring. Further, a 10 Amp fuse
located in the terminal block may be pulled out and replaced as required. Caution! Ensure that VAC power is disconnected and
locked out before servicing driver box.
SV18 RGB LED Driver Box

English:
All drawings of general management, design detail and invention are the property of Underwater Lights USA, LLC and
may be used solely for work contracted or by express written permission of Underwater Lights USA, LLC.This applies
to first hand use and material on loan to others.Any infringement may be liable to penalty and/or compensation
without regard to the question of guilt. All drawings are subject to detail development during the course of
construction, and all rights of reproduction are reserved.Any information provided by Underwater Lights USA, LLC in
either hard copy or electronic format may be subject to change/s without prior purchaser, customer or end user
notice.
French:
Tous les dessins, détails généraux,de conception et d’invention sont la propriété de Underwater Lights USA, LLC et ne
peuvent être utilisés que pour des travaux sous contrat ou avec l’autorisation écrite expresse de Underwater Lights
USA, LLC.Ceci s'applique à la fois à la première utilisation et au matériel emprunté ou visualisé par des tiers.Toute
infraction peut faire l’objet de sanctions et /ou d’une indemnisation sans qu'il soit nécessaire d'établir la preuve de
culpabilité. Tous les dessins font l’objet de développements détaillés pendant la construction et tous les droits de
reproduction sont réservés.Les informations fournies par Underwater Lights USA, LLC, en version papier ou
électronique,peuvent être sujettes à modification(s) sans notification préalable à l'acheteur,au client ou à l'utilisateur
final.
Italian:
Tutti idisegni,generali,dettagli di progettazione edi invenzione sono di proprietà della Underwater Lights USA, LLC e
possono essere utilizzati esclusivamente per il lavoro contratto omediante espressa autorizzazione scritta della
Underwater Lights USA, LLC. Ciò vale sia per la prima utilizzazione sia per il materiale in prestito o visione a terzi.
Qualsiasi infrazione può essere soggetta asanzioni e/o indennizzi senza considerare la questione del senso di colpa.
Tutti i disegni sono soggetti a sviluppo dettagliato durante la costruzione esono riservati tutti i diritti di riproduzione.
Le informazioni fornite dalla Underwater Lights USA, LLC, in copia cartacea o elettronica, possono essere soggette a
modifica/modifiche senza preavviso all'acquirente, al cliente o all'utente finale.
Spanish:
Todos los dibujos, detalles de diseño y creación son propiedad de Underwater Lights USA, LLC ypueden ser utilizados
únicamente para trabajos relacionados o a través de autorización escrita de Underwater Lights USA, LLC. Esto aplica a
utilizarlos de primera mano o a material prestado aotros.Cualquier violación de estos términos puede ser penalizada
y/o una compensación puede ser requerida sin cuestionar la culpabilidad. Todos los dibujos están sujetos a ser
desarrollados en detalle durante el transcurso de la construcción ytodos los derechos de reproducción son reservados.
Toda la información proporcionada por Underwater Lights USA, LLC tanto en forma impresa como digital está sujeta a
cambios en cualquier momento sin notificarle al comprador, cliente o usuario final.
IMPORTANT NOTICE!
Underwater Lights USA, LLC
3406 SW 26th Terrace, C-6/7
Fort Lauderdale, FL33312USA
Phone: [phone]
Fax: [phone]
Internet: www.seavision.com
Email: s[email protected] DOC:041219-1
Underwater Lights Europe Sarl
2323, Chemin de Saint-Bernard
Space Antipolis 6, 06220 Vallauris, France
Phone: [phone]
Fax: [phone]
Internet: www.seavision.com
Email: [email protected]