Unfinished Furniture of Wilmington BD-5603 User manual

ITEM NO.: BD-5603
REVISED JAN 14, 2015
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: 4-DRAWER DESK
: BD-5603

ITEM NO.: BD-5603
REVISED JAN 14, 2015
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your product. Protect the surface of the product with cloth if you are using any
product with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch
A JAMESTOWN DESK WITH
PENCIL DRAWER 1
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: BD-5603
REVISED JAN 14, 2015
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Knob
(38X30mm) 4
2 Pan head screw
(M4X30mm) 4
3 Iron bar 2
STEP 1
Attach Knobs (1) to front of drawers with screws (2). Tighten with a screwdriver (not included).

ITEM NO.: BD-5603
REVISED JAN 14, 2015
Printed in Vietnam
- 4 -
STEP 2
Take the bottom drawers out. Insert iron bars (3) into groove as shown below.