Unfinished Furniture of Wilmington S-5 User manual

ITEM NO.: S-5
REVISED APR 24, 2015
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
:TWO-STEPSTOOL
: S-5

ITEM NO.: S-5
REVISED APR 24, 2015
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Right side
frame 1
B Left side frame 1
C Back rail 1 D
Upper step ,
marked
“upper”
1
E
Lower
step,
marked
“lower”
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Bolt
(M6x50mm) 10
2 Lock washer
(6.5x11mm) 10
3 Flat washer
(6.5x13mm) 10
4 Long Allen key
(5mm) 1
UPPE
R
LOWE

ITEM NO.: S-5
REVISED APR 24, 2015
Printed in Vietnam
- 3 -
STEP 1
Insert the Lower step (E), Back rail (C), Upper step (D) into the Right side frame (A) and Left side frame
(B), as shown below. Then attach the Lower step (E), Back rail (C ), Upper step (D) to the Right side
frame (A) and Left side frame (B) with bolts (1) and washers (2) and (3). Tighten with Allen key (4).
STEP 2
Put the product on a flat level surface and then tighten the bolts.