Unic Pony 4 User manual

Brew Espresso
Steam Milk
Empty Waste Drawer
Daily Coee Cleaning
Steam Wand Cleaning
Programming
Messages
Troubleshooting
www.unic-usa.com © 2018 UNIC USA
2/4 E.S.E.
7 gram pods
v2.16 EN 11-18

Insert Pod
Start Brewing
Empty Waste
Drawer when full
Start Steam
Adjust
Foam
Setting
OFF
Power Switch
ON
no heat ON
with
heat
2/4
Start Water Tap
Cup tray can be mounted
in 3 positions:
Up Down
Attached to drawer
Hot Water Tap

E.S.E.
Easy Serve Espresso
7 gram pods
Store pods so they are
not crushed or damaged!
Insert a pod into 1 of the 2 slots on top
Place pod halfway in slot before releasing
!
Double Shot See Next Page
Open packet
Take care not to tear the pod
Select
Short or
Long pour
Do not use misshapen or
torn pods!
!
Place cup under spout
on same side as pod
Do not drop pod in from
above the slot
Do not force pod
Brew Espresso
Brew Espresso

Select
Short or
Long pour
Use Two E.S.E.
Easy Serve Espresso
7 gram pods
Brew Double Shot
Store pods so they are
not crushed or damaged!
Open packets
Take care not to tear the pods
Do not use misshapen or
torn pods!
!
Insert 1 pod into both slots on top
Place pods halfway in slot before releasing
!
Place cup(s) under spoutsDo not drop pods in from
above the slot
Do not force pods
Brew Espresso

Fill the Pitcher with
milk
Press SteamAir Button
Steam will automatically
shut OFF at the pre-set
temperature
Steam Wand should be
centered in the pitcher
Tip must be at least 1”
below surface of milk
Turn the adjusting
collar to vary the
amount of air in
the milk
•
•
•
••
•
••• More air
• Less air
Remove the pitcher and
wipe the wand and tip with a
clean, damp towel.
Press the Steam or the
SteamAir Button
ON then OFF
to purge
!
The SteamAir wand
MUST be wiped and
purged after each
use to prevent milk
build-up
Steam or Water leaking from
the top of the wand ?
No Foam in milk?
See Cleaning Section
Steam Milk
Steam Milk

Steam Milk

Drawer must be re-
moved for 8 seconds.
The counter will
automatically re-set
after 8 seconds
Screen displays “dA”
(drawer absent) when
drawer is removed
Icon turns green when
counter resets - Replace
drawer
Drawer holds 45 spent
pods
Drawer icon turns red
when full
Screen also ashes “dF”
Empty Waste Drawer
Drawer Level Alerts
Empty waste drawer
when full
Empty Waste Drawer
Empty Waste Drawer

Drawer icon turns
orange when almost
full
Screen ashes “dF” and
displays the number of
drink remaining
Machine will continue
counting down and
ashing a warning
after each cycle
No drinks can be made
when the drawer is full
Empty Waste Drawer
Follow instructions on
previous page
00 06
Drinks can still be
made when the drawer
icon is orange
The drawer may be emptied
at any time, even before the
full message appears
The drawer counter re-
sets to green every-time
the drawer is removed
for 8 seconds
1
Drawer Level Alert
Empty Waste Drawer

Cleaning Tools Needed:
Spout Funnel
#RB 1120
2 Silicone Tablet
Holders
#RB 0100
Cleaning Tablets
#Caza-1.2 tabs
Attach the
Spout Funnel.
Align notches and press
up onto spout.
Install Funnel:
Insert one cleaning
tablet into each holder.
Stretch the silicone
around the edge of the
tablet.
Properly attached
tablet
Attach Tablets:
Before Starting the
Automatic Cleaning
Cycle:
!
1. Install the Spout Funnel
2. Load Tablets into the
Cleaning Tablet Holders
See next page to start the automatic cleaning cycle:
Daily Coee Cleaning
Daily Coee Cleaning

cL ashes when the
inserts are in place.
Press the blue clean-
ing button to start the
cleaning cycle.
Soap and rinse water
will ush through the
spout funnel.
Press and hold the
cleaning button until cL
appears on the screen.
The cleaning button
starts ashing blue.
Carefully insert one
cleaning holder with tab-
let into each pod slot.
Start Cycle:
Before starting
cleaning see previ-
ous page for set-up
instructions
See next page
for nal cleaning
steps
!
The full cycle
takes 3 minutes
Daily Coee Cleaning
Daily Coee Cleani ng

See next page for cleaning alerts:
When nished the dF
(drawer full) or PE (pod
error) message ashes.
Empty and replace
the waste drawer.
Remove the
Cleaning Inserts.
Finish Cleaning Cycle:
Press either double
drink button to clear
the display.
00
Ready
Daily Coee Cleaning
Daily Coee Cleaning

Mandatory Cleaning
The cleaning button
turns orange when a
cleaning is due soon
The screen will ash “cL” and display the
number of drinks remaining before cleaning
lock-out
The button turns red
when the when cleaning
is required
Press and hold the
cleaning to start the
cleaning cycle
Operation is locked out after a pre-set number of pods
are brewed. This is to ensure continued performance.
Each cleaning re-set the counter. The number can be
changed in the programming section.
For low volume machines set the number lower so it will
request a cleaning once a day
Do not set the alert higher than 250!
00
CL CL
19
CL Start Cycle:
20 more drinks are
possible when clean-
ing alert is active
1
Mandatory Cleaning Alert
Daily Coee Cleani ng

Switch OFF
NEVER soak the
steam wand in
cleaner!
!
Unscrew Steam Tip Remove Outer wand Carefully remove the
Temperature Probe
Clean the Steam Tip everyday
or if steam leaks from the top of the wand
The SteamAir Wand may be removed for
cleaning if it has heavy milk build-up
Switch the machine OFF
before removing the Wand!
Next Page
Turn switch all the way
to the left (2 clicks)
Steam Wand Cleaning
Clean Steam Wand

Wipe Inner wand Clean Outer Wand
and Steam Tip in sink
Make sure the probe tip is
pushed all the way down when
reassembling
Install Outer wand
with probe
Insert Temperature
Probe into outer wand
Wipe Temperature
Probe
Replace Steam Tip
Steam Wand Cleaning
Make sure all 12 steam tip
holes are clear!
Clean Steam Wand

Hold triangular stop button for 5 seconds to
enter programming mode.
Program each button by pressing once to start
and once again when desired Time, Temerature,
or Volume is reached.
Small Hot Water
Set volume
Large Hot Water
Set volume
Manual Steam
Set Time
30 sec standard or
1 sec purge
Auto shut-o󰀨 Steam
Set Temperature
Switch the machine OFF to
save the values (2 clicks) Wait 3 seconds!
Turn switch ll the way
back ON (2 clicks)
!
All Buttons ash when
programming is active STOPSTART
Program Steam & Hot Water
Programming

Programming

Button turns yellow and screen shows do
(dose)
Star button turns violet
Press star button to enter programming mode
Ready to program!
All drink buttons ash
Press and hold the
green drawer button for
3 seconds to start
ee
Each of the 4 single buttons needs to
be programmed individually
ee
Program each button to
the desired level using a
pod (Not just water)
The center double buttons are auto-
matically set from the single values
ee
Next Page
Program Coee Dose part 1
86
Programming

1c
Insert a pod on the
side you wish to
program
Press the same button
again to stop the ow when
the desired level is reached
Repeat for the other 3 buttons
No need to program the
center buttons
Set machine into
programming mode
(See previous page)
86
Place measuring cup
under spout
Press desired button
to start programming
ee
START
STOP
Next Page
Program Coee Dose part 2
Co󰀨ee starts dispensing
Programming

Switch the machine OFF
to save the values
(2 clicks)
When nished Pro-
gramming press the
stars key to exit
86
Wait 3 seconds!
Turn switch all the way
back ON
(2 clicks)
!
Save & Exit Coee Dose Programming
Programming

pi
eh
8c
el
Press yellow button to
cycle through the pro-
gramming options
Press and hold the
green drawer button for
3 seconds
(Will turn yellow)
Pre-infusion: Do Not Change
Exhaust: Eject delay Do Not Change
Drawer capacity: Do Not Change
Mandatory Cleaning: Default setting is 250 drinks.
Machine will lock out and require a cleaning.
Must be set for each group.
Dose: Program co󰀨ee doses, see
previous pages
Co󰀨ee Dose (Level in the cup) & Cleaning Alert
are the only user changeable sections !
86
Next Page
Set Mandatory Cleaning Alert
Programming