Urban Electric ALTAMONT WET Quick start guide

ALTAM ONT
ALTAM ONTALTAM ONT
ALTAM ONT WE T
WETWET
WET
ASSEMBLY AND MOUNTING INSTRUCTIONS D C - 1 2 2 0
G E N E R A L N O T E S
G E N E R A L N O T E SG E N E R A L N O T E S
G E N E R A L N O T E S
•THIS LUMINAIRE IS SUITED FOR WET LOCATIONS.
•THIS LUMINAIRE IS UL LISTED. WHEN INSTALLING LUMINAIRE,
CONFORM TO ALL APPLICABLE LOCAL ELECTRICAL CODES,
ORDINANCES, AND THE NATIONAL ELECTRICAL CODE (NEC).
•FOR YOUR SAFETY AND PROPER OPERATION OF LUMINAIRE, READ AND
UNDERSTAND ALL INSTRUCTIONS COMPLETELY BEFORE
COMMENCING INSTALLATION OF THIS LUMINAIRE.
•CAREFULLY UNPACK THE LUMINAIRE AND INSPECT FOR DAMAGE.
•THIS PRODUCT IS RATED FOR ONE 60W MA , TYPE B BULB.
•SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CAUTION
CAUTIONCAUTION
CAUTION
THIS PRODUCT SHOULD BE INSTALLED ONLY BY A LICENSED
ELECTRICIAN.
WARNING
WARNINGWARNING
WARNING
THE ELECTRICITY MUST BE TURNED OFF AT THE MAIN FUSE BO BEFORE
INSTALLING THIS LUMINAIRE. TURNING POWER OFF USING THE LIGHT
SWITCH MAY NOT BE SUFFICIENT TO PREVENT ELECTRICAL SHOCK.
C O M P O N E N T S P R O V I D E D F O R I N S T A L L A T I O N
C O M P O N E N T S P R O V I D E D F O R I N S T A L L A T I O NC O M P O N E N T S P R O V I D E D F O R I N S T A L L A T I O N
C O M P O N E N T S P R O V I D E D F O R I N S T A L L A T I O N
NIPPLE
NIPPLENIPPLE
NIPPLE
CAP
CAPCAP
CAP
WIRE NUTS
WIRE NUTSWIRE NUTS
WIRE NUTS
CROSSBAR
CROSSBARCROSSBAR
CROSSBAR
TUBULAR
TUBULARTUBULAR
TUBULAR
BULB
BULBBULB
BULB
GLASS CYLINDER
GLASS CYLINDERGLASS CYLINDER
GLASS CYLINDER CHECK RING
CHECK RINGCHECK RING
CHECK RING

ALTAM ONT
ALTAM ONTALTAM ONT
ALTAM ONT WE T
WETWET
WET
ASSEMBLY AND MOUNTING INSTRUCTIONS D C - 1 2 2 0
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N SM O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
STEP 1
STEP 1STEP 1
STEP 1
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE JUNCTION
BO FROM THE FUSE BO /CIRCUIT BREAKER. TURNING
POWER OFF AT THE SWITCH IS NOT SUFFICIENT.
STEP 2
STEP 2STEP 2
STEP 2
LOCATE THE JUNCTION BO ON THE WALL. ATTACH THE
PROVIDED CROSS BAR TO THE JUNCTION BO USING THE
JUNCTION BO SCREWS.
STEP 3
STEP 3STEP 3
STEP 3
USING THE WIRE NUTS PROVIDED, MAKE ELECTRICAL
CONNECTIONS BY FOLLOWING THE ELECTRICAL CONFIGURATION
TABLE BELOW. ENSURE THAT ALL ELECTRICAL CONNECTIONS
ARE WRAPPED WITH UL LISTED ELECTRICAL TAPE.
STEP 4
STEP 4STEP 4
STEP 4
ATTACH THE FI TURE TO THE CROSS-BAR USING THE CAP &
CHECK RING PROVIDED. BE CAREFUL TO AVOID SCRATCHING
THE FINISH ON THE FI TURE.
STEP
STEP STEP
STEP 5
55
5
INSTALL LIGHT BULB IN FI TURE SOCKET AND RESTORE POWER
TO THE CIRCUIT. CONFIRM PROPER OPERATION OF THE LIGHT
FI TURE.
STEP
STEP STEP
STEP 6
66
6
TO INSTALL GLASS, REMOVE THE TWO SCREWS THAT FASTEN
THE TOP CAP TO THE FI TURE FRAME AND SET ASIDE.

ALTAM ONT
ALTAM ONTALTAM ONT
ALTAM ONT WE T
WETWET
WET
ASSEMBLY AND MOUNTING INSTRUCTIONS D C - 1 2 2 0
STEP
STEP STEP
STEP 7
77
7
LINE THE GLASS OPENING UP WITH THE BACK OF THE FI TURE
AND GENTLY SLIDE GLASS INTO FI TURE. LET GLASS REST ON
THE BOTTOM OF THE FI TURE. RE-ATTACH THE TOP CAP BY RE-
FASTENING THE TWO SCREW TO THE FI TURE FRAME.
E L E C T R I C A L C O N F I G U R A T I O N T A B L E
E L E C T R I C A L C O N F I G U R A T I O N T A B L EE L E C T R I C A L C O N F I G U R A T I O N T A B L E
E L E C T R I C A L C O N F I G U R A T I O N T A B L E
F R O M H O M E
F R O M H O M EF R O M H O M E
F R O M H O M E F R O M L U M I N A I R E
F R O M L U M I N A I R EF R O M L U M I N A I R E
F R O M L U M I N A I R E
GENERAL NOTE:
GENERAL NOTE:GENERAL NOTE:
GENERAL NOTE: USE UL LISTED WIRE NUTS FOR THE
WIRING CONNECTIONS IN THIS LUMINAIRE. WRAP WIRE
NUT CONNECTIONS WITH UL LISTED ELECTRICAL TAPE.
FOR QUESTIONS, PLEASE CONTACT CLIENT SERVICES AT:
843.723.8140 OR [e-mail]
CONNECT BLACK OR RED (HOT)
HOUSE SUPPLY CIRCUIT WIRE
TO:
LUMINAIRE ROUND WIRE (HOT)
CONNECT WHITE (NEUTRAL)
HOUSE SUPPLY CIRCUIT WIRE
TO:
LUMINAIRE RIBBED WIRE
(NEUTRAL)
CONNECT GREEN INSULATED OR BARE COPPER (GROUND -)
HOUSE SUPPLY CIRCUIT WIRE AND LUMINAIRE BARE STRANDED
WIRE (GROUND -) TO GREEN GROUND SCREW ON CROSSBAR.