Urban Electric BELMONT WALL MM-3900 Quick start guide

BELMONT WALL
ASSEMBLY AND MOUNTING INSTRUCTIONS MM-3900
GENERAL NOTES
•THIS LUMINAIRE IS SUITED FOR WET LOCATIONS.
•WHEN INSTALLING LUMINAIRE, CONFORM TO ALL APPLICABLE
LOCAL ELECTRICAL CODES, ORDINANCES, AND THE NATIONAL
ELECTRICAL CODE (NEC).
•FOR YOUR SAFETY AND PROPER OPERATION OF LUMINAIRE, READ
AND UNDERSTAND ALL INSTRUCTIONS COMPLETELY BEFORE
COMMENCING INSTALLATION OF THIS LUMINAIRE.
•CAREFULLY UNPACK THE LUMINAIRE AND INSPECT FOR DAMAGE.
•THIS PRODUCT IS RATED FOR ONE 60W MAX, TYPE B BULB.
•SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CAUTION
•THIS PRODUCT SHOULD BE INSTALLED ONLY BY A LICENSED
ELECTRICIAN.
•THIS FIXTURE WEIGHS APPROXIMATELY 28 LBS.
WARNING
THE ELECTRICITY MUST BE TURNED OFF AT THE MAIN FUSE BOX
BEFORE INSTALLING THIS LUMINAIRE. TURNING POWER OFF USING THE
LIGHT SWITCH MAY NOT BE SUFFICIENT TO PREVENT ELECTRICAL
SHOCK.
COMPONENTS PROVIDED FOR INSTALLATION
FIXTURE BODY
MOUNTING STUDS (4X)
ACORN NUTS (4X)
BULB
WIRE NUTS
WALL ANCHORS (4X)

BELMONT WALL
ASSEMBLY AND MOUNTING INSTRUCTIONS MM-3900
MOUNTING INSTRUCTIONS –2 PERSON INSTALLATION
STEP 1
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE
JUNCTION BOX FROM THE FUSE BOX/CIRCUIT BREAKER.
TURNING POWER OFF AT THE SWITCH IS NOT SUFFICIENT.
STEP 2
LOCATE THE JUNCTION BOX OR HOUSE SUPPLY CIRCUIT
WIRES COMING FROM THE WALL. MARK HOLES AND
INSTALL WALL ANCHORS AND MOUNTING STUDS IN THE
WALL, LEAVING APPROXIMATELY 11/16” OF THREAD
EXPOSED AT DESIRED INSTALLATION LOCATION.
STEP 3
USING THE WIRE NUTS PROVIDED, MAKE ELECTRICAL
CONNECTIONS BY FOLLOWING THE ELECTRICAL
CONFIGURATION TABLE PROVIDED. ENSURE THAT ALL
ELECTRICAL CONNECTIONS ARE WRAPPED WITH UL-LISTED
ELECTRICAL TAPE.
IMPORTANT: NEVER ALLOW THE FIXTURE TO “HANG” FROM
ELECTRICAL CONNECTIONS OR TO OTHERWISE PUT
PRESSURE ON THE CONNECTIONS. THE WEIGHT OF THE
FIXTURE SHOULD ALWAYS BE PROPERLY SUPPORTED.
STEP 4
ATTACH THE FIXTURE BODY TO THE WALL BY SLIPPING IT
OVER THE MOUNTING STUDS AND TIGHTENING THE ACORN
NUTS. BE CAREFUL TO AVOID SCRATCHING THE FINISH ON
THE FIXTURE.

BELMONT WALL
ASSEMBLY AND MOUNTING INSTRUCTIONS MM-3900
STEP 5
INSTALL THE LIGHT BULB AND RESTORE POWER TO THE
CIRCUIT. CONFIRM PROPER OPERATION OF THE LIGHT
FIXTURE.
ELECTRICAL CONFIGURATION TABLE
FROM HOME
FROM LUMINAIRE
GENERAL NOTE: USE UL LISTED WIRE NUTS FOR THE
WIRING CONNECTIONS IN THIS LUMINAIRE. WRAP WIRE
NUT CONNECTIONS WITH UL LISTED ELECTRICAL
TAPE.
FOR QUESTIONS, PLEASE CONTACT CLIENT SERVICES
AT:
843.723.8140 OR [e-mail]
CONNECT BLACK OR RED (HOT)
HOUSE SUPPLY CIRCUIT WIRE TO:
LUMINAIRE
ROUND/BLACK WIRE
(HOT)
CONNECT WHITE (NEUTRAL)
HOUSE SUPPLY CIRCUIT WIRE TO:
LUMINAIRE
RIBBED/WHITE WIRE
(NEUTRAL)
CONNECT GREEN INSULATED OR BARE COPPER (GROUND -)
HOUSE SUPPLY CIRCUIT WIRE AND LUMINAIRE BARE
STRANDED WIRE (GROUND -) TO GREEN GROUND SCREW ON
CROSSBAR.