US Cutter Titan User manual

support for the left side
bottom stand
screw
screw
Step2
Place the stand beam upright on the T-stand and put the screws into the holes,
but do not tighten them at this step.Repeat the same steps with another stand beam.
stand beam
T-stand for right side
T-stand for left side
Floor Stand Assembly Instructions
Step1
Position the support for the left side
perpendicularly to bottom stand and
place the screws into the holes. Tighten
them to form a left side T-stand
Repeat the same steps with the support
for the right side.

Step4
Place two roll holders into the holes in the roll holder support.
floor stand
roll holder support
roll holder support
Step3
Position the roll holder support’s position to floor stand, and tighten the screws.
roll holder support

Step5
How to install floor stand to machine?
Take off the screw from bottom of machine, insert bolt to top of floor stand,
then tighten the screw.