V-TAC VT-762-2 User manual

INSTRUCTION MANUAL
LED SOLAR WALL LIGHT
TECHNICAL DATA
INTRODUCTION & WARRANTY
WARNING
MODEL VT-762-2
SKU 8276/8277
POWER/LUMEN 1.5W/220LM
LEDs SMD2835*14PCS
LI-ION BATTERY 1200 mAh / 3.7V, 18650
SOLAR PANEL 0.7Wp, Mono-crystalline silicon
WORKING MODE 2 dierent lighting modes
DETECTION ANGLE/AREA 90°/2-6Mtr
VISIBLE DISTANCE 6-7Mtr
IP DEGREE IP 65
LIFESPAN 35,000hrs
INSTALLATION HEIGHT 2-4Mtr
1. Please make sure to turn o the power before starting the installation.
2. Installation must be performed by a qualified person.
3. The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced.
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instruc-
tions carefully before starting the installation and keep this manual handy for future reference. If you have any
another query, please contact our dealer or local vendor from whom you have purchased the product. They are
trained and ready to serve you at the best. The warranty is valid for 2 years from the date of purchase. The
warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company
gives no warranty against damage to any surface due to incorrect removal and installation of the product. The
products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the
warranty. This product is warranted for manufacturing defects only.
0.7Wp, Mono-crystalline silicon
This marking indicates that this product
should not be disposed of with other
household wastes.
Caution, risk of electric shock.
MULTI-LANGUAGE MANUAL QR CODE
Please scan the QR code to access the manual in
multiple languages.

NOTICE
INSTALLATION
WORKING MODES
1. Pls install this light onto flat surface directionally to get enough solar.
2. The lamp will light up when the environmental brightness is less than 30lux.
3. Inside battery is replaceable, 18650 Li-ion battery, 1200mAh/3.7V.
4. Lamp need to be installed 2-4Mtr from the ground.
1. Pls use the card to measure hole position correctly and drill 2 holes.
2. Fix 2 expansion plugs into the holes.
3. Fix a screw to the lower expansion plug with a spare space, insert the notch onto the screw.
4. Straighten the whole lamp and fasten the upper screw.
5. Press the button to adjust to demanded working mode.
Pls press the Button to adjust working mode:
Press 1st time for Mode A. Press 2nd time for Mode B. Press 3rd time for o.
Mode A: Automatically turns on to full brightness (220lm) when
motion is detected in the range ≤6 mtrs and then turns to weak
brightness (front light on & back light on) in 10 seconds of no motion.
Mode B: Automatically turns on to full brightness (2201m) when
motion is detected in the range ≤6 mtrs and then turns to weak
brightness (front light o & back light on) in 10 seconds of no motion.
①
②
③
④
⑤
Hole
Expansion Plug
Screw
Mounting Hole
Button
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: [e-mail]
FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS.
V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B