V-tech Go! Go! Smart Friends Summering Seashell... Assembly Instructions

Parent’s Guide
Shimmering Seashell Castle™
US
91-003390-002

2
2
2
INTRODUCTION
Thank you for purchasing the VTech®Go! Go! Smart Friends®
Shimmering Seashell CastleTM! Watch Pearl the mermaid come to
life when you place her on the three MagicPoint®locations as you
explore the wonders under the sea.
Sea Slide
Light-Up
Shell
Dressing Room
MagicPoint®
Ballroom
MagicPoint®
MagicPoint®
Character
Sand Castle
Vanity
Dolphin
Sea Horse
Crab
Slider
MagicPoint®
Seashell Seat
Sea Animal
Carousel
Swing

3
3
3
INCLUDED IN THIS PACKAGE
NOTE:This toy is not intended for teething.
This toy is not intended for play in water.
•OneMagicPoint®
character - Pearl
•Onecastleroof •Onebackwall
•Onetransparent
wall (B)
•Onetransparent
wall (A)
•Onecastlewall
•Onesmallcastle
cove
•Oneseashellseat
with MagicPoint®
•Twopillars

4
4
4
•Onecarouselpillar •Onecarouselanimals
•Onedoublepillar •Oneswing•Onestarsh
chandelier
•Oneseaslide •Oneseaweed •Onestar
•One2ndoorbasewith
dressing room MagicPoint®
•One1stoorbasewith
ballroom MagicPoint®

5
5
5
Unlock the packaging lock:
There is one packaging lock located on the character.
Use a coin or screwdriver to loosen
the screw.
Pull out the screw with the packaging
lock and discard them.
1
2
Unlock the packaging lock:
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE: Please keep this parent’s guide as it contains important
information.
Turn the packaging lock
counterclockwise several times.
Pull out and discard the
packaging lock.
1
2
•Accessories •Onelabelsheet

6
6
6
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes et vis d’emballage. Ils ne font pas partie du
jouet.
NOTE: Il est conseillé de conserver ce guide des parents car il
comporte des informations importantes.
GETTING STARTED
Battery Installation - Character
1. Make sure the unit is OFF.
2. Locate the battery cover on the bottom of the
unit. Use a screwdriver to loosen the screws.
3. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
4 Replace the battery cover and tighten the
screws to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesforbestperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbonzinc)
or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.

7
7
7
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinre.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
CAUTION:
Adult assembly required. For your child’s safety, do not let your child
play with the toy until it is fully assembled.
ASSEMBLY INSTRUCTIONS
With the VTech®Go! Go! Smart Friends®Shimmering Seashell
Castle™ safety comes rst. To ensure your child’s safety, adult
assembly is required.
1. Insert the Sea Weed into the
1st Floor Base as shown in the
picture.

8
8
8
2. Insert the two Pillars into the 1st Floor Base as shown in the picture.
3. Insert the Star into the 1st Floor
Base as shown in the picture.
4. Insert the Back Wall into the
1st Floor Base as shown in the
picture.
5. Insert Transparent Wall (A) and
Transparent Wall (B) into the
1st Floor Base as shown in the
picture.
Back View

9
9
9
6. Insert the 2nd Floor Base into
the two Pillars, Back Wall,
Transparent Wall (A) and
Transparent Wall (B) as shown in
the picture.
7. Insert the Castle Roof into the
Castle Wall to create the big castle.
8. Insert the big castle into the 2nd
Floor Base as shown in the picture.
9. Insert the Small Castle Cove into
the 2nd Floor Base as shown in
the picture.

10
10
10
10.Attach the Small Castle Cove to
the big castle with the Double
Pillar as shown in the picture.
11.Attach the Carousel Pillar to the
Carousel Animals as shown in the
picture.
12.Insert the Carousel Pillar through
the Small Castle Cove and into the
2nd Floor Base as shown in the
picture.
13.Insert the Starfish Chandelier
into the big castle as shown in the
picture.