V-tech Switch & Go Dinos Smash the T-Rex Assembly Instructions

Parent’s Guide

2
INTRODUCTION
Switch into fun with the Switch & Go Dinos®Smash the T-Rex.
Switch this ferocious T-Rex into an agile Drift Car and back in just a
few simple steps. Ready to smash and crash? Here we go!
Crash Trigger
Game Button
Off / Low / High
Volume Switch

3
INCLUDED IN THIS PACKAGE
• Switch & Go Dinos®Smash the T-Rex
• Parent’s Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws
are not part of this toy and should be discarded for your child’s
safety.
NOTE:
Please keep this Parent’s Guide as it contains important
information.
WARNING:
This toy produces flashes that may trigger epilepsy in
sensitised individuals.

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover on the back of
the unit, use a screwdriver to loosen
the screw and then open the battery
box.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. (For
best performance, alkaline
batteries or fully charged Ni-MH
rechargeable batteries are
recommended).
5. Replace the battery cover and
tighten the screw to secure.
Note: If there is no response when the dino is switched on,
please install brand new batteries and try switching the dino on
again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

7
PRODUCT FEATURES
1. Off / Low / High Volume Switch
To turn the unit On or adjust the volume, slide the
switch to the Low or High Volume position.
To turn the unit Off, slide the switch to the Off
position.
2. Game Button
Press the Game Button to hear fun phrases and cool dinosaur
sounds in Dino mode, or to hear fun phrases and great vehicle
sounds in Vehicle mode.
3. Crash Trigger
Hit the Crash Triggertoseecrashdamagewithaerylight
effect and hear dino or vehicle sounds.

8
5. Automatic Shut-Off
To preserve battery life, Smash the T-Rex will automatically turn
off after approximately 40 seconds without input. Smash the
T-Rex can be woken up again by pressing the Game Button,
hitting the Crash Trigger, or by switching between Dino and
Vehicle mode. Smash the T-Rex will also automatically turn off
when battery power is very low.
HOW TO SWITCH
1. Dino mode. 2. Rotate the dino’s hands
towards the dino’s head.
Then, rotate the feet back
towards the dino’s tail.

9
5. Move the windscreen
forward as illustrated.
6. Vehicle mode.
3. Pull the legs up and
toward the dino’s body as
illustrated.
4. Flip the rear tyres back as
illustrated.
Note: To switch from Vehicle mode to Dino mode, follow the above
steps in reverse order.