V-tech Let's Go, My Friend Pup User manual

Instruction Manual
Let’s Go, My Friend Pup

2
2
2
INTRODUCTION
Thank you for purchasing the Let’s Go, My Friend Pup.
Adopt this pup for hours of interactive play! Two learning modes
introduce colours, numbers & puppy care tips. Walk your pup to hear
interactive responses. Is your puppy hungry or thirsty? Use the play
food and water to care for it!
Toy Bone
Battery Cover
Water Bottle
Hip Pouch
Fabric Belt
Food
Bowl
Lead Recognition
Volume Switch Adoption Card
Touch Sensor
On/Off/Mode
Selector
Colour
Buttons
Mouth
Button
Lead Piece A Lead Piece B

3
3
3
INCLUDED IN THE PACKAGE
• Let’s Go Rescue Pup
• 1 Hip Pouch
• 1 Fabric Belt
• 1 Adoption Card
• Quick Start Guide
• Lead Piece A
• Lead Piece B
• 1 Toy Bone
• 1 Food Bowl
• 1 Water Bottle
• 1 Sticker Sheet

4
4
4
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ASSEMBLY INSTRUCTIONS
With the Let’s Go, My Friend Pup, safety comes first. Adult assembly
required. For your child’s safety, do not let them play with this toy until
it is fully assembled.
Lead Assembly
1. Insert the end of Lead Piece A into the top of Lead Piece B.
2. Insert the end of Lead Piece B into the Lead Recognition on the
collar.
3. Hold the Lead and push the puppy along to play.

5
5
5
Hip Pouch and Belt Assembly
1. Identify the inner portion of the Fabric Belt by locating the long
section of the hook-and-loop closure.
2. With the inner portion of the belt facing the back of the Hip Pouch
where the two slots are, place the Fabric Belt ends through the
Hip Pouch slots from the inside of the pouch.
3. The seams will hold the Fabric Belt in place from the inside of the
Hip Pouch.
4. Put the Fabric Belt around the child’s waist and secure with the
hook-and-loop closure.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
Hip Pouch and Belt Assembly
1. Identify the inner portion of the Fabric Belt by locating the long
section of the hook-and-loop closure.
2. With the inner portion of the belt facing the back of the Hip Pouch
where the two slots are, place the Fabric Belt ends through the
Hip Pouch slots from the inside of the pouch.
3. The seams will hold the Fabric Belt in place from the inside of the
Hip Pouch.
4. Put the Fabric Belt around the child’s waist and secure with the
hook-and-loop closure.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.

6
6
6
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten
the screw to secure.
BATTERY WARNING:
KEEP OUT OF REACH OF CHILDREN.
Adult assembly required for battery installation.
If the battery compartment does not close securely, stop using the
product and keep it away from children.
If you think batteries might have been swallowed or placed inside any
part of the body, seek immediate medical attention.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.

7
7
7
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on
the market after 13th August, 2005.
Help protect the environment by disposing of your
product or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its materials
can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

8
8
8
PERSONALISE YOUR PUPPY
Congratulations on your puppy adoption! Stickers are provided to style
your puppy any way you want. Please securely stick the labels to any
smooth surface on the toy.
Fill out the included Adoption Card and keep it in a safe place. Write
your puppy’s name on the included bone-shaped sticker and stick it on
the puppy’s collar. Two dog tag stickers are provided.
Model: 80-552500-000-001
P/N: 92-012369-000-100
Size: 125 mm x 100 mm
Colour: 4C
Material: 80g Paper + UV+ Glue
客户贴Label
一张Label一份，
按实际尺寸裁切，
不能拼板。
This is to certify that
(your name)
I promise to love and care
for my new pet.
Date
Signature
and has welcomed it to its forever home!
has officially adopted (puppy’s name)
D
A
O
P
T
I
O
N
o
f
E
R
T
I
F
I
C
A
T
E
C
A
D
O
P
T
I
O
N
o
f
C
E
R
T
I
F
I
C
A
T
E
95-001088-000-000
This is to certify that
(your name)
I promise to love and care
for my new pet.
Date
Signature
and has welcomed it to its forever home!
has officially adopted (puppy’s name)
D
A
O
P
T
I
O
N
o
f
E
R
T
I
F
I
C
A
T
E
C
A
D
O
P
T
I
O
N
o
f
C
E
R
T
I
F
I
C
A
T
E
95-001088-000-000

9
9
9
ACTIVATE NORMAL PLAY MODE
This product is in Try-Me mode in the packaging. When you play with
the Let’s Go, My Friend Pup for the first time, slide the On/Off/Mode
Selector to Learning mode or Role-Play mode, and insert the Lead
into the collar. You will hear three beeps to confirm that you have
exited Try-Me mode.
PRODUCT FEATURES
1. On/Off/Mode Selector
To turn the unit On, slide the On/Off/
Mode Selector from Off to Learning
mode or Role-Play mode. To turn
the unit Off, slide the On/Off/Mode
Selector to the Off position.
2. Volume Switch
To adjust the volume, slide the switch
between the Low or High volume
positions.