V-tech Switch & Go Triceratops Fire Truck User manual

Instruction Manual
Triceratops Fire TruckTriceratops Fire Truck

2
INTRODUCTION
Switch into fun with the Switch & Go®Triceratops Fire Truck.
Transform a cool Fire Truck into a Triceratops and back in just a
few simple steps. Launch the Water Burst and release the Rescue
Motorcycle. Let’s go!
Off/Low/High
Volume Selector
Rev-Up
Lever
Water Burst Button
LCD Screen
Voice Button
Launchpad
Motorcycle
Launcher

3
INCLUDED IN THE PACKAGE
• Switch & Go®Triceratops Fire Truck
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’utilisation car il comporte
des informations importantes.
WARNING
Do not aim at eyes or face. Do not discharge any object other than
the projectile provided with this toy.
ATTENTION
Ne viser ni les yeux ni le visage. Ne pas utiliser d’autres projectiles
que ceux fournis avec ce jouet.
NOTE
Please remove all the cable ties before playing Triceratops Fire Truck.

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit and use
a screwdriver to loosen the screw, then open the battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.).
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

6
IMPORTANT : INFORMATIONS CONCERNANT LES
PILES
Les piles fournies avec le produit permettent de tester le jouet en
magasin mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-
carbone et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES :
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.

7
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On or to adjust the volume,
slide the Off/Low/High Volume Selector to
the Low or High volume position. To turn
the unit Off, slide the selector to the Off
position.
2. Voice Button
Press the Voice Button to hear fun phrases
and cool dinosaur sounds in Dino mode. In
Vehicle mode, press the Voice Button to hear
fun phrases and cool fire truck sounds.
3. Water Burst Button
Insert the Water Burst into the Water
Launcher, the Light in the Water Launcher will
be activated, and then press the Water Burst
Button to launch the Water Burst.
4. Rescue Motorcycle
Pull out the Launchpad, and then activate
the Rev-Up Lever several times. Press the
Motorcycle Launcher lever to launch the
Rescue Motorcycle.
5. LCD Screen
The LCD Screen displays dino eye animations
in Dino mode and shows driver animations in
Vehicle mode.

8
6. LED Lights
The LED lights flash along with the sounds in
Dino mode and Vehicle mode.
7. AUTOMATIC SHUT-OFF
To preserve battery life, the Triceratops Fire Truck will
automatically shut off after approximately 20 seconds without
input. The unit can be turned on again by pressing the Voice
Button or by switching between Dino and Vehicle modes.
NOTE
If the unit powers down or if the light fades out during play, please
install a new set of batteries.
2. Rotate the crest down and
then push the head in.
Transformation
1. Begin in Dino mode.
Flip the horns and
close the jaw.

9
3. Adjust the water launcher
launcher backward.
4. Aim the water launcher
forward.
5. Flip up the tail. 6. Flip out the rear legs.
7. Flip the rear legs up. 8. Rotate the lower legs up.

10
9. Rotate the lower legs. 10. Flip the front legs up.
11. Rotate each front leg and
shoulder.
12. Flip the front bumpers out.
13. Push the front bumpers
and wheels in.
14. The unit is now in
Vehicle mode.
To switch back to Dino mode, reverse the steps above.