V-tech Switch&Go Dinos Eggs T-Rex User manual

Instruction Manual
T-Rex
®

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

3
Talk Button
Off / Dino Mode /
Vehicle Mode Switch
INTRODUCTION
Assemble this powerful T-Rex, then switch it to and from a revved-up
race car in just a few simple steps! Add dino roars and cool engine
sound effects along with flashing lights. Stomp, chomp and roar!

4
INCLUDED IN THE PACKAGE
• Switch & Go Dinos® Eggs T-Rex
• 15 Pieces for Assembly
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
GETTING STARTED
Exit Try-Me Mode:
The product is in Try Me mode in the packaging. To exit try-me
mode, just slide the “Off/Dino Mode/Vehicle Mode” Switch from
Vehicle mode to Dino mode/Off.
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the unit. Use a screwdriver to loosen the
screw and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling up
on one end of each battery.
4. Install 1 new AAA (AM-4/LR03) battery
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the
screw to secure.

5
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from the toy before
charging.
• Rechargeable batteries are only to be charged under
adult supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech® cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

7
ASSEMBLY INSTRUCTIONS
1. Identify the following pieces for assembly:
01 02
03
04
05 06 07 08 09
10
11
12
13
14 15

8
2. Separately install the A, B, C, D, E, F, G and H parts as shown in the
illustrations.
A
B
C
01
03
10
11
12 09
02
04
05

9
D
E
F
13
14
15
06
08
C
C
07

10
G
H
B