V-tech SWITCH&GO DINOS Viper the Velociraptor User manual

Instruction Manual
Viper the Velociraptor

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

3
INTRODUCTION
Switch into fun with Switch & Go Dinos®Viper the Velociraptor!
Switch this wild Velociraptor into a tough car and back again in just
a few simple steps! Launch a projectile from Viper at the press of a
button! It’s hunting time! Here we go!
Off / Low Volume / High
Volume Switch
Sounds Button
Accessories
Action ButtonLaunch Button
LCD Screen

4
INCLUDED IN THIS PACKAGE
• One Switch & Go Dinos®Viper the Velociraptor
• Three Projectiles
• One Quick Start Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please save this Instruction Manual it contains important information.
WARNING:Do not aim at eyes and face.
WARNING: Do not discharge any object other than the projectile
provided with this toy.
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the unit. Use a screwdriver to loosen the
screw and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling
up on one end of each battery.
4. Install 2 new AAA batteries following
the diagram inside the battery box. (For
best performance, alkaline batteries
or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under
adult supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech® cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

7
PRODUCT FEATURES
1. Off / Low Volume / High
Volume Switch
To turn the unit On, or to adjust the
volume, slide the switch to the Low
( ) or High ( )Volume position.
To turn the unit Off, slide the switch
to the Off ( ) position.
2. Sounds Button
Press the Sounds Button to hear
fun phrases and wild dino sounds
with light effects in dino mode, or to
hear fun phrases and cool vehicle
sounds in vehicle mode.
3. Action Button
Press the Action Button to trigger
light effects with head and arm
movement.
4. Launch Button
Press the Launch Button to launch
a projectile.

8
5. LCD Screen
The LCD Screen shows dino eye
animations in Dino mode and shows
driver animations in Vehicle mode.
6. Automatic Shut-Off
To preserve battery life, Viper the Velociraptor will
automatically turn off after approximately 20 seconds without
input. Viper the Velociraptor can be woken up again by
pressing the Sounds Button or Action Button, or by switching
between dino and vehicle modes. Viper the Velociraptor will
also automatically turn off when battery power is very low.
NOTE: If the unit powers down or if the light fades out during play,
please install a new set of batteries.

9
1
2
2
1
3
3. Fold out the front wheels and then rotate them 180° before folding
them down into the Dino’s feet.
SWITCHING FROM DINO TO VEHICLE
1. Dino Mode.
2. First, flip up the Dino’s arms, then flip down the Dino’s feet, and
then flip down the Dino’s tail.

10
2
1
Note: To switch from Vehicle mode to Dino mode, follow the above
steps in reverse order.
4. Rotate the legs towards the Dino’s head.
5. Flip the front bumper up towards the Dino’s head and rotate the
projectile 90° so it is forward facing. Viper is now in Vehicle mode.