V-tech Toot-Toot Drivers Garage User manual

© 2015 VTech
Printed in China
91-003022-001
User’s Manual
Garage

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
SMARTPOINT®
TOW TRUCK
ELECTRONIC GATE
ON/OFF/VOLUME
CONTROL SWITCH 3 LIGHT-UP
BUTTONS
LIFT/
LAUNCHER
HELICOPTER
PA D
VEHICLE LIFT
9 SMARTPOINT®
LOCATIONS
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Drivers®Garage!
Park, play and learn with the Toot-Toot Drivers®Garage. This
interactive garage features three floors of pretend play and learning fun.
INTRODUCTION

33
INCLUDED IN THIS PACKAGE
INCLUDED IN THIS PACKAGE
One lift tower One vehicle lift
One welcome gate
One SmartPoint®
tow truck
One SmartPoint®
car wash
One curved ramp track One straight ramp track
One ground floor
SmartPoint
®
platform
One first floor
SmartPoint
®
platform
One second floor
SmartPoint
®
platform
One fuel accessory

4
INCLUDED IN THIS PACKAGE
Two male/female connector tracks
Two male connector tracks
One 90-degree female track
One 90-degree male track
One lift support piece
One user’s manual
Two label sheets
One snap-in large support
One medium support
One snap-in small support
One mini support
Two snap-in mini supports
x2

5
GETTING STARTED
BATTERY INSTALLATION – TOW TRUCK
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the tow truck. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new “AAA” (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance.)
4. Replace the battery cover and tighten
the screw to secure.
GETTING STARTED
CAUTION:
Adult assembly required. For your child’s safety, do
not let your child play with the toy until it is fully
assembled.
WARNING:
All packing materials, such as tape, plastic sheets, packaging
locks and tags are not part of this toy, and should be discarded
for your child’s safety.
NOTE:
Please keep this user’s manual as it contains important
information.
Unlock the packaging locks:
Turn the packaging lock counter-clockwise
several times.
Pull out and discard the packaging lock.

6
BATTERY INSTALLATION - GARAGE
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the top
platform of the Garage. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new ‘AA’ (AM-3/LR6) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
BATTERY NOTICE

7
LABEL INSTRUCTIONS
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com
Please stick the labels to the play set securely as
indicated on the following page:
1
4
56
8
8
910
7
11
12
216 17
13 14 15

8
9
2
17
16
510
13
15
11
14
12 6
1
4
7
LABEL INSTRUCTIONS
8

9
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
With the VTech® Toot-Toot Drivers®Garage safety comes first.To
ensureyourchild’ssafety,adultassemblyisrequired.
1. With the ground floor platform right-side up, insert the two snap-in
mini supports into the slots on the ground floor platform as shown.
The snap-in mini supports will fit in the slots snuggly. The teeth on
the snap-in mini supports will grip to the ground floor platform.
2. With the rst oor platform upside-down, insert the snap-in small
support into the slot on the rst oor platform as shown. The snap-
in small support will t in the slot snuggly. The tooth on the small
support will grip to the rst oor platform.