Valcourt AC04312 User manual

Printed in Canada
CONSUMER: READ AND KEEP THIS MANUAL FOR REFERENCE
INSTALLER: LEAVE THIS MANUAL WITH THE COMPLIANCE.
46228A
2020-11-05
WARNING
If the information in these instructions are not
followed exactly, a re or explosion may result
causing property damage, personal injury or
loss of life.
— Do not store or use gasoline or other
ammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your
building.
• Leave the building immediately.
• Immediately call your gas supplier
from a neighbor’s phone.
Follow the gas supplier’s
instructions.
• If you cannot reach your gas
supplier, call the re department.
— Installation and service must be
performed by a qualied installer,
service agency or the gas supplier.
WARNING
If not installed, operated and maintained
in accordance with the manufacturer’s
instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
CLASSIC WOOD LOGS
WITH BLACK GLOWING WOOL
AC04312
FOR USE ON FG00004 & FG00007 (S42) FIREPLACE
INSTALLATION INSTRUCTIONS
ENGLISH
NOTICE: Ceramic fiber logs
may differ in appearance from
those shown in this manual.
We suggest that our
gas hearth products be
installed and serviced
by professionals who
are certified in the U.S.
by the National Fireplace
Institute®(NFI) as NFI
Gas Specialists.
Safety tested
according to ANSI Z21.88-2017
and CSA 2.33-2017 standards
by an accredited laboratory.

Page 2 Installation Instructions - Log Set
ENGLISH
AC04312 LOG SET IDENTIFICATION
INDEX LETTER
& DESCRIPTION
PART
NUMBER FRONT VIEW TOP VIEW
(A) FRONT LEFT LOG 22393
(B) FRONT RIGHT LOG 22394
(C) REAR CROSSOVER
LOG 22395
(D) REAR LOG 22396
(E) SMALL LEFT LOG 22397
(F) LEFT CROSSOVER
LOG 22398
(G) RIGHT CROSSOVER
LOG 22399

Page 3
Installation instructions - Log Set
ENGLISH
LOG SET INSTALLATION PREPARATION
LOG PLACEMENT
The positioning of logs is critical to safe and clean operation of this fireplace. Sooting and other
problems may result if the logs are not properly and firmly positioned in the fireplace.
BEFORE BEGINNING THE INSTALLATION:
1. Remove the Invisimesh barrier and glass door on fireplace using instructions from the fireplace manual.
2. Install liner kit before the logset. See the liner instructions manual for further information.
3. Place logs in position as shown in Figure 1 and the following pages.
DO NOT force holes into the logs. Install using the holes and pins located in each log.
Figure 1: Log placement

Page 4 Installation Instructions - Log Set
ENGLISH
1
23
45
7
6
8
Figure 2: Pins and tabs location
Figure 3: Allowed area for glowing wool placement
WARNING
Apply loose material (glowing wool) per instruction manual. DO NOT apply extra material
not supplied with this kit. All previously applied loose material (glowing wool) must be
removed prior to reapplication. Do not cover the burner’s upper rectangular ports with
loose material (glowing wool).
Figure 4: Allowed area for lava rocks (AC04381) placement.
LOG SET INSTALLATION PREPARATION

Page 5
Installation instructions - Log Set
ENGLISH
LOG SET PLACEMENT
STEP 1: Lift the tabs 6, 7 and 8 located on the burner cover as shown in figure 2.
STEP 2: Put the log A on the pins 1 and 2 located on the burner.

Page 6 Installation Instructions - Log Set
ENGLISH
LOG SET PLACEMENT
STEP 3: Put the log B on the pin 3 located on the burner and on the pin on top of log A.
STEP 4: Put the log C on the pin on top of log B and on the left side of the pilot.

Page 7
Installation instructions - Log Set
ENGLISH
LOG SET PLACEMENT
STEP 5: Put the log D on the pins 4 and 5 located on the log support.

Page 8 Installation Instructions - Log Set
ENGLISH
LOG SET PLACEMENT
STEP 6: Put the log E on tab 6 located on the burner cover.

Page 9
Installation instructions - Log Set
ENGLISH
LOG SET PLACEMENT
STEP 7: Put the log G on the pin on the top right of log D and on tab 8 located on the burner cover.

Page 10 Installation Instructions - Log Set
ENGLISH
LOG SET PLACEMENT
STEP 8: Put the log F on the pin on the top left of log D and on tab 7 located on the burner cover.
STEP 9: This completes the log set installation. Display the glowing wool in the designated
areas as shown in figure 3 all around the circular ports. Use pieces not bigger that a 10 cent
coin. Display the lava rocks in the designated areas as shown on figure 4. Reinstall the glass
door and
Invisimesh barrier as indicated in the fireplace manual.

Page 11
Installation instructions - Log Set
ENGLISH

Stove Builder International inc.
250, De Copenhague street,
St-Augustin-de-Desmaures (Québec), Canada
G3A 2H3
418-908-8002
This document is available for free download on the
manufacturer’s website. It is a copyrighted document.
Resale is strictly prohibited. The manufacturer may update
this document from time to time and cannot be responsible
for problems, injuries, or damages arising out of the use
of information contained in any document obtained from
unauthorized sources.